[PATCH RFC v4 10/15] irqchip/gic-v3: Don't return errors from gic_acpi_match_gicc()

[Russell King (Oracle)]

From: James Morse <james.morse at arm.com>

gic_acpi_match_gicc() is only called via gic_acpi_count_gicr_regions().
It should only count the number of enabled redistributors, but it
also tries to sanity check the GICC entry, currently returning an
error if the Enabled bit is set, but the gicr_base_address is zero.

Adding support for the online-capable bit to the sanity check will
complicate it, for no benefit. The existing check implicitly depends on
gic_acpi_count_gicr_regions() previous failing to find any GICR regions
(as it is valid to have gicr_base_address of zero if the redistributors
are described via a GICR entry).

Instead of complicating the check, remove it. Failures that happen at
this point cause the irqchip not to register, meaning no irqs can be
requested. The kernel grinds to a panic() pretty quickly.

Without the check, MADT tables that exhibit this problem are still
caught by gic_populate_rdist(), which helpfully also prints what went
wrong:
| CPU4: mpidr 100 has no re-distributor!

Signed-off-by: James Morse <james.morse at arm.com>
Reviewed-by: Gavin Shan <gshan at redhat.com>
Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
Changes since RFC v3 (smaller series):
 * Move acpi_gicc_is_usable() change in gic_acpi_match_gicc() into
   following patch so this is only about the error return.
 * Tweak commit message
---
 drivers/irqchip/irq-gic-v3.c | 13 ++-----------
 1 file changed, 2 insertions(+), 11 deletions(-)

diff --git a/drivers/irqchip/irq-gic-v3.c b/drivers/irqchip/irq-gic-v3.c
index 98b0329b7154..8deb671c4ff7 100644
--- a/drivers/irqchip/irq-gic-v3.c
+++ b/drivers/irqchip/irq-gic-v3.c
@@ -2422,19 +2422,10 @@ static int __init gic_acpi_match_gicc(union acpi_subtable_headers *header,
 	 * If GICC is enabled and has valid gicr base address, then it means
 	 * GICR base is presented via GICC
 	 */
-	if (acpi_gicc_is_usable(gicc) && gicc->gicr_base_address) {
+	if (acpi_gicc_is_usable(gicc) && gicc->gicr_base_address)
 		acpi_data.enabled_rdists++;
-		return 0;
-	}
 
-	/*
-	 * It's perfectly valid firmware can pass disabled GICC entry, driver
-	 * should not treat as errors, skip the entry instead of probe fail.
-	 */
-	if (!acpi_gicc_is_usable(gicc))
-		return 0;
-
-	return -ENODEV;
+	return 0;
 }
 
 static int __init gic_acpi_count_gicr_regions(void)
-- 
2.30.2