[PATCH v3 3/7] clk: samsung: gs101: add support for cmu_peric1

[Tudor Ambarus]

On 1/29/24 17:46, André Draszik wrote:
> CMU_PERIC1 is the clock management unit used for the peric1 block which
> is used for additional USI, I3C and PWM interfaces/busses. Add support
> for muxes, dividers and gates of cmu_peric1, except for
> CLK_GOUT_PERIC1_IP which isn't well described in the datasheet and
> which downstream also ignores (similar to cmu_peric0).
> 
> Two clocks have been marked as CLK_IS_CRITICAL for the following
> reason:
>     * disabling them makes it impossible to access any peric1
>       registers, (including those two registers).
>     * disabling gout_peric1_lhm_axi_p_peric1_i_clk sometimes has the
>       additional effect of making the whole system unresponsive.
> 
> One clock marked as CLK_IGNORE_UNUSED needs to be kept on until we have
> updated the respective driver for the following reason:
>     * gout_peric1_gpio_peric1_pclk is required by the pinctrl
>       configuration. With this clock disabled, reconfiguring the pins
>       (for USI/I2C, USI/UART) will hang during register access.
>       Since pinctrl-samsung doesn't support a clock at the moment, we
>       just keep the kernel from disabling it at boot, until we have an
>       update for pinctrl-samsung, at which point we'll drop the flag.
> 
> Signed-off-by: André Draszik <andre.draszik at linaro.org>
> Reviewed-by: Sam Protsenko <semen.protsenko at linaro.org>
> Reviewed-by: Peter Griffin <peter.griffin at linaro.org>
> 

Looks good to me:

Reviewed-by: Tudor Ambarus <tudor.ambarus at linaro.org>