[PATCH v3 17/17] spi: s3c64xx: use bitfield access macros

[Sam Protsenko]

On Fri, Jan 26, 2024 at 9:23 PM Tudor Ambarus <tudor.ambarus at linaro.org> wrote:
>
> Hi, Sam,
>
> Thanks for the review feedback!
>
> On 1/26/24 20:12, Sam Protsenko wrote:
> >> -               val |= S3C64XX_SPI_MODE_BUS_TSZ_HALFWORD;
> >> -               val |= S3C64XX_SPI_MODE_CH_TSZ_HALFWORD;
> >> +               val |= FIELD_PREP(S3C64XX_SPI_MODE_BUS_TSZ_MASK,
> >> +                                 S3C64XX_SPI_MODE_BUS_TSZ_HALFWORD) |
> >> +                      FIELD_PREP(S3C64XX_SPI_MODE_CH_TSZ_MASK,
> >> +                                 S3C64XX_SPI_MODE_CH_TSZ_HALFWORD);
> > Two people complained it makes the code harder to read. Yet it's not
> > addressed in v3. Please see my comments for your previous submission
> > explaining what can be done, and also Andi's comment on that matter.
>
> I kept these intentionally. Please read my reply on that matter or the
> cover letter to this patch set.
>

I read it. But still don't like it :) I'm sure it's possible to do
this modification, but at the same time keep the code clean an easy to
read. The code above -- I don't like at all, sorry. It was much better
before this patch, IMHO.

> > Also I think new patch series are being submitted a bit too fast,
> > people might not have enough time to provide the review.
>
> This patch set contains patches that are already reviewed or too simple
> to being lagged.
>

Ok, agreed.

> Cheers,
> ta