[PATCH v2 21/28] spi: s3c64xx: infer fifosize from the compatible

[Tudor Ambarus]

On 1/25/24 17:18, Mark Brown wrote:
> On Thu, Jan 25, 2024 at 02:49:59PM +0000, Tudor Ambarus wrote:
> 
>> Infer the FIFO size from the compatible, where all the instances of the
>> SPI IP have the same FIFO size. This way we no longer depend on the SPI
>> alias from the device tree to select the FIFO size, thus we remove the
>> dependency of the driver on the SPI alias.
> 
>>  static const struct s3c64xx_spi_port_config s3c2443_spi_port_config = {
>> -	.fifo_lvl_mask	= { 0x7f },
>> +	.fifosize	= 64,
>>  	.rx_lvl_offset	= 13,
>>  	.tx_st_done	= 21,
>>  	.clk_div	= 2,
> 
> I'm having real trouble associating the changelog with the change here.
> This appears to be changing from specifying the mask for the FIFO level
> register to specifying the size of the FIFO and unrelated to anything to
> do with looking things up from the compatible?

Let me try to explain everything.

In the driver there is a weird dependency between the SPI of_alias ID,
s3c64xx_spi_port_config.fifo_lvl_mask and the IP's FIFO depth.

s3c64xx_spi_port_config.fifo_lvl_mask is not a 1:1 match with the
SPI_STATUSn.{RX, TX}_FIFO_LVL register field. Those fields are defined
in the datasheet as:
+#define S3C64XX_SPI_ST_RX_FIFO_LVL		GENMASK(23, 15)
+#define S3C64XX_SPI_ST_TX_FIFO_LVL		GENMASK(14, 6)

Thus the register mask is on 9 bits, but the driver used either 0x1ff or
0x7f, which was not reflecting the real register mask. Patch 10/28
updates the driver to use the full register mask regardless of the FIFO
depth configuration.

Another problem with s3c64xx_spi_port_config.fifo_lvl_mask is that it
was used as a way to determine the FIFO depth. The SPI of_alias ID was
used as an index in this array to determine the FIFO depth with
something like
	fifo_depth = (fifo_lvl_mask[alias_id] >> 1) + 1
For example, if one wanted to specify a 64 FIFO length (0x40), it would
have configured the FIFO level to 127 (0x7f).

The patch set breaks this weird dependencies. Obviously the FIFO depth
must be tightly tied by the compatible and not by an alias. I tied the
FIFO depth to the compatible in 2 ways:
1/ For SoCs that have all the SPI nodes with the same FIFO depth, I
chose to deduce the FIFO depth from the compatible. Instead of
specifying "samsung,spi-fifosize" for all the gs101 SPI nodes in the
device tree, I chose to infer it from the compatible. I know for sure
that all the gs101 SPI nodes have 64 bytes FIFO depths, thus don't
pollute the device tree with superfluous info. (patches 20/28 and 21/28)
2/ For SoCs that have instances of the SPI IP with different FIFO
depths, specify the node's FIFO depth via the "samsung,spi-fifosize" dt
property. (patch 23/28)

Hope this helps. Please tell if you want me to elaborate on something.