[PATCH v2] ARM: multi_v7_defconfig: Add more TI Keystone support

Andrew Davis afd at ti.com
Thu Jan 25 08:31:45 PST 2024


The Keystone platforms used their own keystone_defconfig mostly to
enable CONFIG_ARM_LPAE which could not be added to the multi_v7 config.
Now that we have multi_v7_lpae_defconfig/lpae.config target we can and
should use that defconfig for Keystone. Add the remaining must-have
options for Keystone support to multi_v7_defconfig.

TI_SCI_*:
TI_MESSAGE_MANAGER:
 Allows TI-SCI communication with system control firmware (PMMC) on K2G.

TI_KEYSTONE_NETCP*:
KEYSTONE_NAVIGATOR*:
 Network driver, needed for NFS boot.

PCI_KEYSTONE*:
CAN_C_CAN*:
INPUT_GPIO_DECODER:
SPI_CADENCE_QUADSPI:
PWM_TIECAP:
 Miscellaneous on-chip peripherals. Added as modules where possible.

RESET_TI*:
 Used by DSP Remoteproc driver.

bloat-o-meter:
add/remove: 387/0 grow/shrink: 6/0 up/down: 130945/0 (130945)
Total: Before=22791863, After=22922808, chg +0.57%

Signed-off-by: Andrew Davis <afd at ti.com>
---

Changes for v2:
 - Added some info on why each of these configs were added
 - Added bloat-o-meter output

 arch/arm/configs/multi_v7_defconfig | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm/configs/multi_v7_defconfig b/arch/arm/configs/multi_v7_defconfig
index ecb3e286107a4..04ba674e03f60 100644
--- a/arch/arm/configs/multi_v7_defconfig
+++ b/arch/arm/configs/multi_v7_defconfig
@@ -183,6 +183,7 @@ CONFIG_PCIE_RCAR_HOST=y
 CONFIG_PCI_RCAR_GEN2=y
 CONFIG_PCI_LAYERSCAPE=y
 CONFIG_PCI_DRA7XX_EP=y
+CONFIG_PCI_KEYSTONE_HOST=y
 CONFIG_PCI_ENDPOINT=y
 CONFIG_PCI_ENDPOINT_CONFIGFS=y
 CONFIG_PCI_EPF_TEST=m
@@ -191,6 +192,7 @@ CONFIG_DEVTMPFS_MOUNT=y
 CONFIG_OMAP_OCP2SCP=y
 CONFIG_ARM_SCMI_PROTOCOL=y
 CONFIG_RASPBERRYPI_FIRMWARE=y
+CONFIG_TI_SCI_PROTOCOL=y
 CONFIG_TRUSTED_FOUNDATIONS=y
 CONFIG_BCM47XX_NVRAM=y
 CONFIG_BCM47XX_SPROM=y
@@ -280,6 +282,8 @@ CONFIG_DWMAC_DWC_QOS_ETH=y
 CONFIG_TI_CPSW=y
 CONFIG_TI_CPSW_SWITCHDEV=y
 CONFIG_TI_CPTS=y
+CONFIG_TI_KEYSTONE_NETCP=y
+CONFIG_TI_KEYSTONE_NETCP_ETHSS=y
 CONFIG_XILINX_EMACLITE=y
 CONFIG_SFP=m
 CONFIG_BROADCOM_PHY=y
@@ -292,6 +296,8 @@ CONFIG_CAN_AT91=m
 CONFIG_CAN_FLEXCAN=m
 CONFIG_CAN_SUN4I=y
 CONFIG_CAN_XILINXCAN=y
+CONFIG_CAN_C_CAN=m
+CONFIG_CAN_C_CAN_PLATFORM=m
 CONFIG_CAN_RCAR=m
 CONFIG_CAN_MCP251X=y
 CONFIG_MDIO_MSCC_MIIM=m
@@ -335,6 +341,7 @@ CONFIG_INPUT_MISC=y
 CONFIG_INPUT_PM8941_PWRKEY=y
 CONFIG_INPUT_MAX77693_HAPTIC=m
 CONFIG_INPUT_MAX8997_HAPTIC=m
+CONFIG_INPUT_GPIO_DECODER=m
 CONFIG_INPUT_CPCAP_PWRBUTTON=m
 CONFIG_INPUT_AXP20X_PEK=m
 CONFIG_INPUT_DA9063_ONKEY=m
@@ -436,6 +443,7 @@ CONFIG_SPI_ATMEL_QUADSPI=m
 CONFIG_SPI_BCM2835=y
 CONFIG_SPI_BCM2835AUX=y
 CONFIG_SPI_CADENCE=y
+CONFIG_SPI_CADENCE_QUADSPI=y
 CONFIG_SPI_DAVINCI=y
 CONFIG_SPI_FSL_QUADSPI=m
 CONFIG_SPI_GXP=m
@@ -1073,6 +1081,7 @@ CONFIG_HWSPINLOCK_OMAP=y
 CONFIG_HWSPINLOCK_QCOM=y
 CONFIG_OMAP2PLUS_MBOX=y
 CONFIG_BCM2835_MBOX=y
+CONFIG_TI_MESSAGE_MANAGER=y
 CONFIG_QCOM_APCS_IPC=y
 CONFIG_STM32_IPCC=m
 CONFIG_QCOM_IPCC=y
@@ -1133,11 +1142,15 @@ CONFIG_ARCH_TEGRA_2x_SOC=y
 CONFIG_ARCH_TEGRA_3x_SOC=y
 CONFIG_ARCH_TEGRA_114_SOC=y
 CONFIG_ARCH_TEGRA_124_SOC=y
+CONFIG_SOC_TI=y
+CONFIG_KEYSTONE_NAVIGATOR_QMSS=y
+CONFIG_KEYSTONE_NAVIGATOR_DMA=y
 CONFIG_RASPBERRYPI_POWER=y
 CONFIG_QCOM_CPR=y
 CONFIG_QCOM_RPMHPD=y
 CONFIG_QCOM_RPMPD=y
 CONFIG_ROCKCHIP_PM_DOMAINS=y
+CONFIG_TI_SCI_PM_DOMAINS=y
 CONFIG_ARM_EXYNOS_BUS_DEVFREQ=m
 CONFIG_ARM_TEGRA_DEVFREQ=m
 CONFIG_DEVFREQ_EVENT_EXYNOS_NOCP=m
@@ -1193,10 +1206,13 @@ CONFIG_PWM_STM32=m
 CONFIG_PWM_STM32_LP=m
 CONFIG_PWM_SUN4I=y
 CONFIG_PWM_TEGRA=y
+CONFIG_PWM_TIECAP=m
 CONFIG_PWM_VT8500=y
 CONFIG_KEYSTONE_IRQ=y
 CONFIG_RESET_MCHP_SPARX5=y
 CONFIG_RESET_SCMI=y
+CONFIG_RESET_TI_SCI=m
+CONFIG_RESET_TI_SYSCON=m
 CONFIG_PHY_SUN4I_USB=y
 CONFIG_PHY_SUN9I_USB=y
 CONFIG_PHY_BRCM_USB=m
-- 
2.39.2




More information about the linux-arm-kernel mailing list