[PATCH] ARM: dts: imx6ull-dhcom: Remove /omit-if-no-ref/ from node usdhc1-pwrseq
Christoph Niedermaier
cniedermaier at dh-electronics.com
Thu Jan 25 04:46:21 PST 2024
Remove /omit-if-no-ref/ from node usdhc1-pwrseq, because if the compile
flag -@ (include symbols) is used the node will always be there. In this
case, GPIO H is not released and therefore cannot be used. Therefore,
remove this node manually from the corresponding devicetree file and
don't rely on /omit-if-no-ref/.
Signed-off-by: Christoph Niedermaier <cniedermaier at dh-electronics.com>
---
Cc: Rob Herring <robh+dt at kernel.org>
Cc: Krzysztof Kozlowski <krzysztof.kozlowski+dt at linaro.org>
Cc: Conor Dooley <conor+dt at kernel.org>
Cc: Shawn Guo <shawnguo at kernel.org>
Cc: Marek Vasut <marex at denx.de>
Cc: Fabio Estevam <festevam at denx.de>
Cc: NXP Linux Team <linux-imx at nxp.com>
Cc: kernel at dh-electronics.com
Cc: devicetree at vger.kernel.org
Cc: linux-kernel at vger.kernel.org
To: linux-arm-kernel at lists.infradead.org
---
arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som-cfg-sdcard.dtsi | 4 +++-
arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som.dtsi | 2 +-
2 files changed, 4 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som-cfg-sdcard.dtsi b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som-cfg-sdcard.dtsi
index 040421f9c970..5e39f8dc1351 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som-cfg-sdcard.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som-cfg-sdcard.dtsi
@@ -14,10 +14,12 @@
*/
/*
- * To use usdhc1 as SD card, the WiFi node must be deleted.
+ * To use usdhc1 as SD card, the WiFi node must be deleted. The associated
+ * pwrseq node is also deleted in order to ensure that GPIO H is released.
* BT is also not available, so remove BT from the UART node.
*/
/delete-node/ &brcmf;
+/delete-node/ &usdhc1_pwrseq;
/delete-node/ &bluetooth;
/ {
diff --git a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som.dtsi b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som.dtsi
index 830b5a5064f2..f914fe3818c2 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcom-som.dtsi
@@ -52,7 +52,7 @@
};
/* SoM with WiFi/BT: WiFi pin WL_REG_ON is connected to a DHCOM GPIO */
- /omit-if-no-ref/ usdhc1_pwrseq: usdhc1-pwrseq {
+ usdhc1_pwrseq: usdhc1-pwrseq {
compatible = "mmc-pwrseq-simple";
reset-gpios = <&gpio5 9 GPIO_ACTIVE_LOW>; /* GPIO H */
};
--
2.11.0
More information about the linux-arm-kernel
mailing list