[PATCH 2/2] arm64: dts: rockchip: rock-pi-e: fix location of snps properties

[Trevor Woerner]

A number of snps (Synopsys) properties are not in their correct location.

Fixes: b918e81f2145 ("arm64: dts: rockchip: rk3328: Add Radxa ROCK Pi E")
Signed-off-by: Trevor Woerner <twoerner at gmail.com>
---
 arch/arm64/boot/dts/rockchip/rk3328-rock-pi-e.dts | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3328-rock-pi-e.dts b/arch/arm64/boot/dts/rockchip/rk3328-rock-pi-e.dts
index 096cfa19036e..0739b8fec86e 100644
--- a/arch/arm64/boot/dts/rockchip/rk3328-rock-pi-e.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3328-rock-pi-e.dts
@@ -150,8 +150,11 @@ &gmac2io {
 	phy-mode = "rgmii";
 	phy-supply = <&vcc_io>;
 	pinctrl-names = "default";
-	pinctrl-0 = <&rgmiim1_pins>;
+	pinctrl-0 = <&rgmiim1_pins>, <&eth_phy_reset_pin>;
 	snps,aal;
+	snps,reset-gpio = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>;
+	snps,reset-active-low;
+	snps,reset-delays-us = <0 10000 50000>;
 	snps,rxpbl = <0x4>;
 	snps,txpbl = <0x4>;
 	tx_delay = <0x26>;
@@ -165,13 +168,10 @@ mdio {
 
 		rtl8211: ethernet-phy at 1 {
 			reg = <1>;
-			pinctrl-0 = <&eth_phy_int_pin>, <&eth_phy_reset_pin>;
+			pinctrl-0 = <&eth_phy_int_pin>;
 			pinctrl-names = "default";
 			interrupt-parent = <&gpio1>;
 			interrupts = <24 IRQ_TYPE_LEVEL_LOW>;
-			reset-assert-us = <10000>;
-			reset-deassert-us = <50000>;
-			reset-gpios = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>;
 		};
 	};
 };
-- 
2.43.0.76.g1a87c842ece3