[RFC 7/9] dt-bindings: wireless: ath11k: describe QCA6390

[Kalle Valo]

Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org> writes:

> On 04/01/2024 14:01, Bartosz Golaszewski wrote:
>
>> diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath11k-pci.yaml b/Documentation/devicetree/bindings/net/wireless/qcom,ath11k-pci.yaml
>> index 817f02a8b481..f584c25f4276 100644
>> --- a/Documentation/devicetree/bindings/net/wireless/qcom,ath11k-pci.yaml
>> +++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath11k-pci.yaml
>> @@ -16,6 +16,7 @@ description: |
>>  properties:
>>    compatible:
>>      enum:
>> +      - pci17cb,1101  # QCA6390
>>        - pci17cb,1103  # WCN6855
>>  
>>    reg:
>> @@ -27,6 +28,19 @@ properties:
>>        string to uniquely identify variant of the calibration data for designs
>>        with colliding bus and device ids
>>  
>> +  enable-gpios:
>> +    description: GPIO line enabling the ATH11K module when asserted.
>> +    maxItems: 1
>> +
>> +  vddpmu-supply:
>> +    description: VDD_PMU supply regulator handle
>> +
>> +  vddpcie1-supply:
>> +    description: VDD_PCIE1 supply regulator handle
>> +
>> +  vddpcie2-supply:
>> +    description: VDD_PCIE2 supply regulator handle
>
> Looks like these are valid only for specific variant, so you should have
> allOf:if:then disallowing other properties when not applicable. The same
> applies for existing properties which might not exist on qca6390.

And it would be good to provide more information in the commit log about
the platforms where this is used, otherwise the context might not be
clear. Or maybe document that in the bindings file, not sure.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches