[net-next PATCH v9 3/5] net: phy: add support for PHY LEDs polarity modes

[Andrew Lunn]

On Fri, Jan 05, 2024 at 03:27:15PM +0100, Christian Marangi wrote:
> Add support for PHY LEDs polarity modes. Some PHY require LED to be set
> to active low to be turned ON. Adds support for this by declaring
> active-low property in DT.
> 
> PHY driver needs to declare .led_polarity_set() to configure LED
> polarity modes. Function will pass the index with the LED index and a
> bitmap with all the required modes to set.
> 
> Current supported modes are:
> - active-low with the flag PHY_LED_ACTIVE_LOW. LED is set to active-low
>   to turn it ON.
> - inactive-high-impedance with the flag PHY_LED_INACTIVE_HIGH_IMPEDANCE.
>   LED is set to high impedance to turn it OFF.
> 
> Signed-off-by: Christian Marangi <ansuelsmth at gmail.com>

Reviewed-by: Andrew Lunn <andrew at lunn.ch>

    Andrew