[PATCH v3 3/5] thermal/cpufreq: Remove arch_update_thermal_pressure()

[Vincent Guittot]

arch_update_thermal_pressure() aims to update fast changing signal which
should be averaged using PELT filtering before being provided to the
scheduler which can't make smart use of fast changing signal.
cpufreq now provides the maximum freq_qos pressure on the capacity to the
scheduler, which includes cpufreq cooling device. Remove the call to
arch_update_thermal_pressure() in cpufreq cooling device as this is
handled by cpufreq_get_pressure().

Signed-off-by: Vincent Guittot <vincent.guittot at linaro.org>
Reviewed-by: Lukasz Luba <lukasz.luba at arm.com>
Acked-by: Viresh Kumar <viresh.kumar at linaro.org>
---
 drivers/thermal/cpufreq_cooling.c | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/drivers/thermal/cpufreq_cooling.c b/drivers/thermal/cpufreq_cooling.c
index e2cc7bd30862..e77d3b44903e 100644
--- a/drivers/thermal/cpufreq_cooling.c
+++ b/drivers/thermal/cpufreq_cooling.c
@@ -448,7 +448,6 @@ static int cpufreq_set_cur_state(struct thermal_cooling_device *cdev,
 				 unsigned long state)
 {
 	struct cpufreq_cooling_device *cpufreq_cdev = cdev->devdata;
-	struct cpumask *cpus;
 	unsigned int frequency;
 	int ret;
 
@@ -465,8 +464,6 @@ static int cpufreq_set_cur_state(struct thermal_cooling_device *cdev,
 	ret = freq_qos_update_request(&cpufreq_cdev->qos_req, frequency);
 	if (ret >= 0) {
 		cpufreq_cdev->cpufreq_state = state;
-		cpus = cpufreq_cdev->policy->related_cpus;
-		arch_update_thermal_pressure(cpus, frequency);
 		ret = 0;
 	}
 
-- 
2.34.1