[PATCH v3 3/8] ARM: dts: stm32: rename mmc_vcard to vcc-3v3 on stm32f769-disco

[Dario Binacchi]

In the schematics of document UM2033, the power supply for the micro SD
card is the same 3v3 voltage that is used to power other devices on the
board. By generalizing the name of the voltage regulator, it can be
referenced by other nodes in the device tree without creating
misunderstandings.

This patch is preparatory for future developments.

Signed-off-by: Dario Binacchi <dario.binacchi at amarulasolutions.com>
---

(no changes since v1)

 arch/arm/boot/dts/st/stm32f769-disco.dts | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/st/stm32f769-disco.dts b/arch/arm/boot/dts/st/stm32f769-disco.dts
index 5d12ae25b327..8632bd866272 100644
--- a/arch/arm/boot/dts/st/stm32f769-disco.dts
+++ b/arch/arm/boot/dts/st/stm32f769-disco.dts
@@ -92,9 +92,9 @@ usbotg_hs_phy: usb-phy {
 		clock-names = "main_clk";
 	};
 
-	mmc_vcard: mmc_vcard {
+	vcc_3v3: vcc_3v3 {
 		compatible = "regulator-fixed";
-		regulator-name = "mmc_vcard";
+		regulator-name = "vcc_3v3";
 		regulator-min-microvolt = <3300000>;
 		regulator-max-microvolt = <3300000>;
 	};
@@ -128,7 +128,7 @@ &rtc {
 
 &sdio2 {
 	status = "okay";
-	vmmc-supply = <&mmc_vcard>;
+	vmmc-supply = <&vcc_3v3>;
 	cd-gpios = <&gpioi 15 GPIO_ACTIVE_LOW>;
 	broken-cd;
 	pinctrl-names = "default", "opendrain", "sleep";
-- 
2.43.0