[PATCH] arm64/boot: Enable EL2 requirements for BRBE
Anshuman Khandual
anshuman.khandual at arm.com
Thu Feb 29 03:49:23 PST 2024
Fine grained trap control for BRBE registers, and instructions access need
to be configured in HDFGRTR_EL2, HDFGWTR_EL2 and HFGITR_EL2 registers when
kernel enters at EL1 but EL2 is present. This changes __init_el2_fgt() as
required.
Similarly cycle and mis-prediction capture need to be enabled in BRBCR_EL1
and BRBCR_EL2 when the kernel enters either into EL1 or EL2. This adds new
__init_el2_brbe() to achieve this objective.
This also updates Documentation/arch/arm64/booting.rst with all the above
EL2 along with MDRC_EL3.SBRBE requirements.
First this replaces an existing hard encoding (1 << 62) with corresponding
applicable macro HDFGRTR_EL2_nPMSNEVFR_EL1_MASK.
Signed-off-by: Anshuman Khandual <anshuman.khandual at arm.com>
---
Booting requirement code has been separated out from the main driver and
this has been slightly tested, will be added as a separate patch in the
next version.
Documentation/arch/arm64/booting.rst | 26 ++++++++
arch/arm64/include/asm/el2_setup.h | 90 +++++++++++++++++++++++++++-
2 files changed, 113 insertions(+), 3 deletions(-)
diff --git a/Documentation/arch/arm64/booting.rst b/Documentation/arch/arm64/booting.rst
index b57776a68f15..512210da7dd2 100644
--- a/Documentation/arch/arm64/booting.rst
+++ b/Documentation/arch/arm64/booting.rst
@@ -349,6 +349,32 @@ Before jumping into the kernel, the following conditions must be met:
- HWFGWTR_EL2.nSMPRI_EL1 (bit 54) must be initialised to 0b01.
+ For CPUs with feature Branch Record Buffer Extension (FEAT_BRBE):
+
+ - If the kernel is entered at EL2 and EL1 is present:
+
+ - BRBCR_EL1.CC (bit 3) must be initialised to 0b1.
+ - BRBCR_EL1.MPRED (bit 4) must be initialised to 0b1.
+
+ - If the kernel is entered at EL1 and EL2 is present:
+
+ - BRBCR_EL2.CC (bit 3) must be initialised to 0b1.
+ - BRBCR_EL2.MPRED (bit 4) must be initialised to 0b1.
+
+ - HDFGRTR_EL2.nBRBDATA (bit 61) must be initialised to 0b1.
+ - HDFGRTR_EL2.nBRBCTL (bit 60) must be initialised to 0b1.
+ - HDFGRTR_EL2.nBRBIDR (bit 59) must be initialised to 0b1.
+
+ - HDFGWTR_EL2.nBRBDATA (bit 61) must be initialised to 0b1.
+ - HDFGWTR_EL2.nBRBCTL (bit 60) must be initialised to 0b1.
+
+ - HFGITR_EL2.nBRBIALL (bit 56) must be initialised to 0b1.
+ - HFGITR_EL2.nBRBINJ (bit 55) must be initialised to 0b1.
+
+ - If EL3 is present:
+
+ - MDCR_EL3.SBRBE (bits 33:32) must be initialised to 0b11.
+
For CPUs with the Scalable Matrix Extension FA64 feature (FEAT_SME_FA64):
- If EL3 is present:
diff --git a/arch/arm64/include/asm/el2_setup.h b/arch/arm64/include/asm/el2_setup.h
index b7afaa026842..7c12a8e658d4 100644
--- a/arch/arm64/include/asm/el2_setup.h
+++ b/arch/arm64/include/asm/el2_setup.h
@@ -154,6 +154,41 @@
.Lskip_set_cptr_\@:
.endm
+#ifdef CONFIG_ARM64_BRBE
+/*
+ * Enable BRBE cycle count and miss-prediction
+ *
+ * BRBE requires both BRBCR_EL1.CC and BRBCR_EL2.CC fields, be set
+ * for the cycle counts to be available in BRBINF<N>_EL1.CC during
+ * branch record processing after a PMU interrupt. This enables CC
+ * field on both these registers while still executing inside EL2.
+ *
+ * BRBE driver would still be able to toggle branch records cycle
+ * count support via BRBCR_EL1.CC field regardless of whether the
+ * kernel ends up executing in EL1 or EL2.
+ *
+ * The same principle applies for branch record mis-prediction info
+ * as well, thus requiring MPRED field to be set on both BRBCR_EL1
+ * and BRBCR_EL2 while still executing inside EL2.
+ */
+.macro __init_el2_brbe
+ mrs x1, id_aa64dfr0_el1
+ ubfx x1, x1, #ID_AA64DFR0_EL1_BRBE_SHIFT, #4
+ cbz x1, .Lskip_brbe_\@
+
+ mov_q x0, BRBCR_ELx_CC | BRBCR_ELx_MPRED
+ msr_s SYS_BRBCR_EL2, x0
+
+ __check_hvhe .Lset_brbe_nvhe_\@, x1
+ msr_s SYS_BRBCR_EL12, x0 // VHE
+ b .Lskip_brbe_\@
+
+.Lset_brbe_nvhe_\@:
+ msr_s SYS_BRBCR_EL1, x0 // NVHE
+.Lskip_brbe_\@:
+.endm
+#endif /* CONFIG_ARM64_BRBE */
+
/* Disable any fine grained traps */
.macro __init_el2_fgt
mrs x1, id_aa64mmfr0_el1
@@ -161,16 +196,48 @@
cbz x1, .Lskip_fgt_\@
mov x0, xzr
+ mov x2, xzr
mrs x1, id_aa64dfr0_el1
ubfx x1, x1, #ID_AA64DFR0_EL1_PMSVer_SHIFT, #4
cmp x1, #3
b.lt .Lset_debug_fgt_\@
+
/* Disable PMSNEVFR_EL1 read and write traps */
- orr x0, x0, #(1 << 62)
+ orr x0, x0, #HDFGRTR_EL2_nPMSNEVFR_EL1_MASK
+ orr x2, x2, #HDFGWTR_EL2_nPMSNEVFR_EL1_MASK
.Lset_debug_fgt_\@:
+#ifdef CONFIG_ARM64_BRBE
+ mrs x1, id_aa64dfr0_el1
+ ubfx x1, x1, #ID_AA64DFR0_EL1_BRBE_SHIFT, #4
+ cbz x1, .Lskip_brbe_reg_fgt_\@
+
+ /*
+ * Disable read traps for the following registers
+ *
+ * [BRBSRC|BRBTGT|RBINF]_EL1
+ * [BRBSRCINJ|BRBTGTINJ|BRBINFINJ|BRBTS]_EL1
+ */
+ orr x0, x0, #HDFGRTR_EL2_nBRBDATA_MASK
+
+ /*
+ * Disable write traps for the following registers
+ *
+ * [BRBSRCINJ|BRBTGTINJ|BRBINFINJ|BRBTS]_EL1
+ */
+ orr x2, x2, #HDFGWTR_EL2_nBRBDATA_MASK
+
+ /* Disable read and write traps for [BRBCR|BRBFCR]_EL1 */
+ orr x0, x0, #HDFGRTR_EL2_nBRBCTL_MASK
+ orr x2, x2, #HDFGWTR_EL2_nBRBCTL_MASK
+
+ /* Disable read traps for BRBIDR_EL1 */
+ orr x0, x0, #HDFGRTR_EL2_nBRBIDR_MASK
+
+.Lskip_brbe_reg_fgt_\@:
+#endif /* CONFIG_ARM64_BRBE */
msr_s SYS_HDFGRTR_EL2, x0
- msr_s SYS_HDFGWTR_EL2, x0
+ msr_s SYS_HDFGWTR_EL2, x2
mov x0, xzr
mrs x1, id_aa64pfr1_el1
@@ -193,7 +260,21 @@
.Lset_fgt_\@:
msr_s SYS_HFGRTR_EL2, x0
msr_s SYS_HFGWTR_EL2, x0
- msr_s SYS_HFGITR_EL2, xzr
+ mov x0, xzr
+#ifdef CONFIG_ARM64_BRBE
+ mrs x1, id_aa64dfr0_el1
+ ubfx x1, x1, #ID_AA64DFR0_EL1_BRBE_SHIFT, #4
+ cbz x1, .Lskip_brbe_insn_fgt_\@
+
+ /* Disable traps for BRBIALL instruction */
+ orr x0, x0, #HFGITR_EL2_nBRBIALL_MASK
+
+ /* Disable traps for BRBINJ instruction */
+ orr x0, x0, #HFGITR_EL2_nBRBINJ_MASK
+
+.Lskip_brbe_insn_fgt_\@:
+#endif /* CONFIG_ARM64_BRBE */
+ msr_s SYS_HFGITR_EL2, x0
mrs x1, id_aa64pfr0_el1 // AMU traps UNDEF without AMU
ubfx x1, x1, #ID_AA64PFR0_EL1_AMU_SHIFT, #4
@@ -228,6 +309,9 @@
__init_el2_nvhe_idregs
__init_el2_cptr
__init_el2_fgt
+#ifdef CONFIG_ARM64_BRBE
+ __init_el2_brbe
+#endif
.endm
#ifndef __KVM_NVHE_HYPERVISOR__
--
2.25.1
More information about the linux-arm-kernel
mailing list