[PATCH v2 3/4] ARM: dts: marvell: Add 7 segment LED display on x530

[Chris Packham]

The Allied Telesis x530 products have a 7 segment LED display which is
used for node identification when the devices are stacked. Represent
this as a gpio-7seg device.

Signed-off-by: Chris Packham <chris.packham at alliedtelesis.co.nz>
---

Notes:
    Changes in v2:
    - Use compatible = "generic-gpio=7seg" to keep checkpatch.pl happy

 arch/arm/boot/dts/marvell/armada-385-atl-x530.dts | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts b/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts
index 5a9ab8410b7b..f55a3dc6b6de 100644
--- a/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts
+++ b/arch/arm/boot/dts/marvell/armada-385-atl-x530.dts
@@ -43,6 +43,17 @@ uart0: serial at 12000 {
 			};
 		};
 	};
+
+	led-7seg {
+		compatible = "generic-gpio-7seg";
+		segment-gpios = <&led_7seg_gpio 0 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 1 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 2 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 3 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 4 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 5 GPIO_ACTIVE_LOW
+				 &led_7seg_gpio 6 GPIO_ACTIVE_LOW>;
+	};
 };
 
 &pciec {
@@ -149,7 +160,7 @@ i2c at 3 {
 			#size-cells = <0>;
 			reg = <3>;
 
-			gpio at 20 {
+			led_7seg_gpio: gpio at 20 {
 				compatible = "nxp,pca9554";
 				gpio-controller;
 				#gpio-cells = <2>;
-- 
2.43.2