[PATCH v3 17/18] PCI: j721e: add reset GPIO to struct j721e_pcie

[Thomas Richard]

On 2/15/24 17:04, Andy Shevchenko wrote:
> On Thu, Feb 15, 2024 at 04:18:02PM +0100, Thomas Richard wrote:
>> From: Théo Lebrun <theo.lebrun at bootlin.com>
>>
>> Add reset GPIO to struct j721e_pcie, so it can be used at suspend and
>> resume stages.
> 
> ...
> 
>>  	case PCI_MODE_RC:
>> -		gpiod = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW);
>> -		if (IS_ERR(gpiod)) {
>> -			ret = PTR_ERR(gpiod);
>> +		pcie->reset_gpio = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW);
>> +		if (IS_ERR(pcie->reset_gpio)) {
>> +			ret = PTR_ERR(pcie->reset_gpio);
>>  			if (ret != -EPROBE_DEFER)
>>  				dev_err(dev, "Failed to get reset GPIO\n");
>>  			goto err_get_sync;
>> @@ -504,9 +504,9 @@ static int j721e_pcie_probe(struct platform_device *pdev)
>>  		 * mode is selected while enabling the PHY. So deassert PERST#
>>  		 * after 100 us.
>>  		 */
>> -		if (gpiod) {
>> +		if (pcie->reset_gpio) {
>>  			usleep_range(100, 200);
>> -			gpiod_set_value_cansleep(gpiod, 1);
>> +			gpiod_set_value_cansleep(pcie->reset_gpio, 1);
>>  		}
> 
> Instead of all this, just add one line assignment. Moreover, before or after
> this patch refactor the code to use ret = dev_err_probe(...); pattern that
> eliminates those deferral probe checks.

Hi Andy,

I'm not sure what you exactly want when you write "just add one line
assignment".
For the dev_err_probe() it's okay, it will be fixed in the next iteration.

Regards,

-- 
Thomas Richard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com