[PATCH 2/3] iio: adc: rockchip_saradc: use mask for write_enable bitfield

[Heiko Stübner]

Am Freitag, 23. Februar 2024, 13:45:22 CET schrieb Quentin Schulz:
> From: Quentin Schulz <quentin.schulz at theobroma-systems.com>
> 
> Some of the registers on the SARADCv2 have bits write protected except
> if another bit is set. This is usually done by having the lowest 16 bits
> store the data to write and the highest 16 bits specify which of the 16
> lowest bits should have their value written to the hardware block.
> 
> The write_enable mask for the channel selection was incorrect because it
> was just the value shifted by 16 bits, which means it would only ever
> write bits and never clear them. So e.g. if someone starts a conversion
> on channel 5, the lowest 4 bits would be 0x5, then starts a conversion
> on channel 0, it would still be 5.
> 
> Instead of shifting the value by 16 as the mask, let's use the OR'ing of
> the appropriate masks shifted by 16.
> 
> Note that this is not an issue currently because the only SARADCv2
> currently supported has a reset defined in its Device Tree, that reset
> resets the SARADC controller before starting a conversion on a channel.
> However, this reset is handled as optional by the probe function and
> thus proper masking should be used in the event an SARADCv2 without a
> reset ever makes it upstream.
> 
> Fixes: 757953f8ec69 ("iio: adc: rockchip_saradc: Add support for RK3588")
> Cc: Quentin Schulz <foss+kernel at 0leil.net>
> Signed-off-by: Quentin Schulz <quentin.schulz at theobroma-systems.com>

Reviewed-by: Heiko Stuebner <heiko at sntech.de>