[PATCH v2 1/4] arm64: dts: imx8mp-phyboard-pollux: Add and update rtc devicetree node

[Yashwanth Varakala]

The interrupt of the RTC is connected on the carrier board
phyBOARD-i.MX8MP-Pollux.

RTC trickle-charger devicetree property is dependent on the
phyboard-pollux design.

Signed-off-by: Yashwanth Varakala <y.varakala at phytec.de>
---
Changes in v2:
-Corrected the commit message.

 .../dts/freescale/imx8mp-phyboard-pollux-rdk.dts  | 15 +++++++++++++++
 .../boot/dts/freescale/imx8mp-phycore-som.dtsi    |  1 -
 2 files changed, 15 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts b/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts
index c8640cac3edc..96754ce633ed 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts
@@ -139,6 +139,15 @@ &snvs_pwrkey {
 	status = "okay";
 };
 
+&rv3028 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_rtc>;
+	interrupt-parent = <&gpio4>;
+	interrupts = <19 IRQ_TYPE_LEVEL_LOW>;
+	wakeup-source;
+	trickle-resistor-ohms = <3000>;
+};
+
 /* debug console */
 &uart1 {
 	pinctrl-names = "default";
@@ -295,6 +304,12 @@ MX8MP_IOMUXC_SD2_RESET_B__GPIO2_IO19	0x40
 		>;
 	};
 
+	pinctrl_rtc: rtcgrp {
+		fsl,pins = <
+			MX8MP_IOMUXC_SAI1_TXD7__GPIO4_IO19	0x1C0
+		>;
+	};
+
 	pinctrl_uart1: uart1grp {
 		fsl,pins = <
 			MX8MP_IOMUXC_UART1_RXD__UART1_DCE_RX	0x40
diff --git a/arch/arm64/boot/dts/freescale/imx8mp-phycore-som.dtsi b/arch/arm64/boot/dts/freescale/imx8mp-phycore-som.dtsi
index c976c3b6cbc6..e6ffa6a6b68b 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp-phycore-som.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mp-phycore-som.dtsi
@@ -175,7 +175,6 @@ eeprom at 51 {
 	rv3028: rtc at 52 {
 		compatible = "microcrystal,rv3028";
 		reg = <0x52>;
-		trickle-resistor-ohms = <3000>;
 	};
 };
 
-- 
2.34.1