[PATCH 2/4] arm64: dts: imx8mp-phyboard-pollux: Set debug uart muxing to 0x140

[Teresa Remmet]

Hello Yashwanth,

Am Mittwoch, dem 21.02.2024 um 15:12 +0100 schrieb Yashwanth Varakala:
> From: Benjamin Hahn <B.Hahn at phytec.de>
> 
> Set Pull Resistors Enable bit to put signal into a defined state.
> 
> Signed-off-by: Yannic Moog <y.moog at phytec.de>
> Signed-off-by: Benjamin Hahn <B.Hahn at phytec.de>

your Signed-off-by is missing here. Same with the other patches.

And somehow the authorship of the patch got messed up. Benjamin updated
the patch but this patch was actually created by Yannic. Same issue
with the other ones. 

Teresa

> ---
>  arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts | 4 ++-
> -
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-
> rdk.dts b/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-
> rdk.dts
> index 96754ce633ed..36b59d0c67f7 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mp-phyboard-pollux-rdk.dts
> @@ -312,8 +312,8 @@ MX8MP_IOMUXC_SAI1_TXD7__GPIO4_IO19  0x1C0
>  
>         pinctrl_uart1: uart1grp {
>                 fsl,pins = <
> -                       MX8MP_IOMUXC_UART1_RXD__UART1_DCE_RX    0x40
> -                       MX8MP_IOMUXC_UART1_TXD__UART1_DCE_TX    0x40
> +                       MX8MP_IOMUXC_UART1_RXD__UART1_DCE_RX    0x140
> +                       MX8MP_IOMUXC_UART1_TXD__UART1_DCE_TX    0x140
>                 >;
>         };
>  

-- 
PHYTEC Messtechnik GmbH | Barcelona-Allee 1 | 55129 Mainz, Germany

Geschäftsführer: Dipl.-Ing. Michael Mitezki, Dipl.-Ing. Bodo Huber,
Dipl.-Ing. (FH) Markus Lickes | Handelsregister Mainz HRB 4656 |
Finanzamt Mainz | St.Nr. 266500608, DE 149059855