[PATCH 13/13] MIPS: mobileye: eyeq5: add resets to I2C controllers

[Krzysztof Kozlowski]

On 16/02/2024 10:05, Théo Lebrun wrote:
> Hello,
> 
> On Fri Feb 16, 2024 at 8:59 AM CET, Krzysztof Kozlowski wrote:
>> On 15/02/2024 17:52, Théo Lebrun wrote:
>>> Add resets properties to each I2C controller. This depends on the
>>> reset-eyeq5 platform reset controller driver.
>>>
>>> Signed-off-by: Théo Lebrun <theo.lebrun at bootlin.com>
>>> ---
>>
>> This should be squashed with previous patch adding i2c controllers.
>> Don't add incomplete nodes just to fix them in next patch.
> 
> The goal was to isolate reset phandles to a single patch. The series

That was what you did, not the goal. If that's the goal, then it is
clearly wrong.

> with this patch dropped works because resets in their default state are
> deasserted, so this isn't a fix. And it allows testing the series on
> hardware with only the base platform series, which I found useful.

Series or half-of-series? Anyway, commits must be logical chunks, so one
chunk is to add I2C controllers, not "part of I2C controllers". DTS is
also independent of drivers (and it will go via different trees!), so
whatever dependency you think of, it does not exist.

Best regards,
Krzysztof