[PATCH v2 1/2] ARM: dts: imx6dl-yapp4: Fix typo in the QCA switch register address

[Michal Vokáč]

This change does not have any functional effect. The switch works just
fine without this patch as it has full access to all the addresses
on the bus. This is simply a clean-up to set the node name address
and reg address to the same value.

Fixes: 15b43e497ffd ("ARM: dts: imx6dl-yapp4: Use correct pseudo PHY address for the switch")
Signed-off-by: Michal Vokáč <michal.vokac at ysoft.com>
---
changes in v2:
- Reword the commit message so it is clear that this patch does not
  fix a functional problem.

 arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi b/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi
index cfb0fc924b42..5763f8253d51 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6dl-yapp4-common.dtsi
@@ -143,7 +143,7 @@
 
 		switch at 10 {
 			compatible = "qca,qca8334";
-			reg = <10>;
+			reg = <0x10>;
 			reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
 
 			switch_ports: ports {
-- 
2.1.4