[RESEND PATCH v2 0/4] arm64: dts: ti: Modify pinmux for wkup_uart0 and mcu_uart0

Bhavya Kapoor b-kapoor at ti.com
Mon Feb 12 02:44:13 PST 2024


WKUP_PADCONFIG registers for wkup_uart0 and mcu_uart0 lies under
wkup_pmx2 for J7200. Thus, modify pinmux for both of them. Also,
remove the redundant clock-frequency property from mcu_uart0 node.

Only Tx and Rx Signal lines for wkup_uart0 are brought out on
J721S2 Common Proc Board and J784S4 EVM, but CTS and RTS signal lines
are not brought out. Thus, remove pinmux for CTS and RTS signal lines
for wkup_uart0 in J721S2 and J784S4.

v1 Link : https://lore.kernel.org/all/20240208110602.931573-1-b-kapoor@ti.com/

Changelog v1->v2:
 - Divided Pinmux and clock frequency patch(1/3) for J7200 into 2 patches
 - Change commit message to include wkup_uart0 for referring to the instance

Rebased to 20240212

Bhavya Kapoor (4):
  arm64: dts: ti: k3-j7200-common-proc-board: Modify Pinmux for
    wkup_uart0 and mcu_uart0
  arm64: dts: ti: k3-j7200-common-proc-board: Remove clock-frequency
    from mcu_uart0
  arm64: dts: ti: k3-j721s2-common-proc-board: Remove Pinmux for CTS and
    RTS in wkup_uart0
  arm64: dts: ti: k3-j784s4-evm: Remove Pinmux for CTS and RTS in
    wkup_uart0

 .../boot/dts/ti/k3-j7200-common-proc-board.dts | 18 +++++++++---------
 .../dts/ti/k3-j721s2-common-proc-board.dts     |  2 --
 arch/arm64/boot/dts/ti/k3-j784s4-evm.dts       |  2 --
 3 files changed, 9 insertions(+), 13 deletions(-)

-- 
2.34.1




More information about the linux-arm-kernel mailing list