[PATCH net-next v5 6/7] net: dsa: mt7530: correct port capabilities of MT7988

[Arınç ÜNAL via B4 Relay]

From: Arınç ÜNAL <arinc.unal at arinc9.com>

On the switch on the MT7988 SoC, as shown in Block Diagram 8.1.1.3 on page
125 of "MT7988A Wi-Fi 7 Generation Router Platform: Datasheet (Open
Version) v0.1", there are only 4 PHYs. That's port 0 to 3. Set the case for
ports which connect to switch PHYs to '0 ... 3'.

Port 4 and 5 are not used at all in this design.

Link: https://wiki.banana-pi.org/Banana_Pi_BPI-R4#Documents [1]
Acked-by: Daniel Golle <daniel at makrotopia.org>
Reviewed-by: Vladimir Oltean <olteanv at gmail.com>
Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
---
 drivers/net/dsa/mt7530.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index e1fdef5766fb..4ca7ba94788e 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -2577,7 +2577,7 @@ static void mt7988_mac_port_get_caps(struct dsa_switch *ds, int port,
 
 	switch (port) {
 	/* Ports which are connected to switch PHYs. There is no MII pinout. */
-	case 0 ... 4:
+	case 0 ... 3:
 		__set_bit(PHY_INTERFACE_MODE_INTERNAL,
 			  config->supported_interfaces);
 		break;

-- 
2.40.1