[PATCH 2/2] arm64: dts: allwinner: Transpeed 8K618-T: add WiFi nodes

[Andre Przywara]

In contrast to other devices using Allwinner SoCs, the Transpeed 8K618-T
TV box uses a mainline supported WiFi chip: it's a Broadcom 4335
compatible, packaged by a company called Murata.
It works nicely with the Linux driver, when providing the respective
firmware files.

Add the required DT nodes to let the kernel find the SDIO device.

Signed-off-by: Andre Przywara <andre.przywara at arm.com>
---
 .../sun50i-h618-transpeed-8k618-t.dts         | 23 +++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h618-transpeed-8k618-t.dts b/arch/arm64/boot/dts/allwinner/sun50i-h618-transpeed-8k618-t.dts
index 8ea1fd41aeba..7ec4098e707b 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h618-transpeed-8k618-t.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h618-transpeed-8k618-t.dts
@@ -16,6 +16,7 @@ / {
 
 	aliases {
 		serial0 = &uart0;
+		ethernet1 = &sdio_wifi;
 	};
 
 	chosen {
@@ -39,6 +40,15 @@ reg_vcc3v3: vcc3v3 {
 		regulator-max-microvolt = <3300000>;
 		regulator-always-on;
 	};
+
+	wifi_pwrseq: wifi_pwrseq {
+		compatible = "mmc-pwrseq-simple";
+		clocks = <&rtc CLK_OSC32K_FANOUT>;
+		clock-names = "ext_clock";
+		pinctrl-0 = <&x32clk_fanout_pin>;
+		pinctrl-names = "default";
+		reset-gpios = <&pio 6 18 GPIO_ACTIVE_LOW>; /* PG18 */
+	};
 };
 
 &ehci0 {
@@ -60,6 +70,19 @@ &mmc0 {
 	status = "okay";
 };
 
+&mmc1 {
+	vmmc-supply = <&reg_dldo1>;
+	vqmmc-supply = <&reg_aldo1>;
+	mmc-pwrseq = <&wifi_pwrseq>;
+	bus-width = <4>;
+	non-removable;
+	status = "okay";
+
+	sdio_wifi: wifi at 1 {
+		reg = <1>;
+	};
+};
+
 &mmc2 {
 	vmmc-supply = <&reg_dldo1>;
 	vqmmc-supply = <&reg_aldo1>;
-- 
2.25.1