[PATCH v3 0/6] firmware: arm_scmi: Add SCMI v3.2 pincontrol protocol basic support

[Peng Fan]

> Subject: Re: [PATCH v3 0/6] firmware: arm_scmi: Add SCMI v3.2 pincontrol
> protocol basic support
> 
> On Mon, Jan 29, 2024 at 08:36:50PM +0800, Peng Fan wrote:
> > Hi Sudeep, Cristian
> >
> > Would you pick up patch 1-4?
> 
> I will for v6.9 sometime.
> 
> > And for i.MX95 OEM extenstion, do you have any suggestions?
> > I have two points:
> > 1. use vendor compatible. This would also benefit when supporting
> > vendor protocol.
> 
> May be, but that was never on plate for standard protocols. So I don't like
> that approach either.
> 
> > 2. Introduce a property saying supporting-generic-pinconf
> >
> 
> I am not sure what you mean by that. But that doesn't sound right especial in
> context of SCMI. So I would say no.
> 
> > How do you think?
> >
> 
> I don't have any other suggestions than fix your driver to use the pinmux
> properly with features in the upstream pinmux subsystem.

So for OEM specific units in Pin Configuration Type and Enumerations,
Any ideas how to support them if not talking about i.MX?

Thanks,
Peng.

> 
> --
> Regards,
> Sudeep