[PATCH net-next v5 6/9] net: sparx5: verify RGMII speeds

[Daniel Machon]

When doing a port config, we verify the port speed against the PHY mode
and supported speeds of that PHY mode. Add checks for the four RGMII phy
modes: RGMII, RGMII_ID, RGMII_TXID and RGMII_RXID.

Reviewed-by: Steen Hegelund <Steen.Hegelund at microchip.com>
Reviewed-by: Horatiu Vultur <horatiu.vultur at microchip.com>
Tested-by: Robert Marko <robert.marko at sartura.hr>
Signed-off-by: Daniel Machon <daniel.machon at microchip.com>
---
 drivers/net/ethernet/microchip/sparx5/sparx5_port.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/net/ethernet/microchip/sparx5/sparx5_port.c b/drivers/net/ethernet/microchip/sparx5/sparx5_port.c
index 0a1374422ccb..86d6c9e9ec7c 100644
--- a/drivers/net/ethernet/microchip/sparx5/sparx5_port.c
+++ b/drivers/net/ethernet/microchip/sparx5/sparx5_port.c
@@ -257,6 +257,15 @@ static int sparx5_port_verify_speed(struct sparx5 *sparx5,
 		     conf->speed != SPEED_25000))
 			return sparx5_port_error(port, conf, SPX5_PERR_SPEED);
 		break;
+	case PHY_INTERFACE_MODE_RGMII:
+	case PHY_INTERFACE_MODE_RGMII_ID:
+	case PHY_INTERFACE_MODE_RGMII_TXID:
+	case PHY_INTERFACE_MODE_RGMII_RXID:
+		if (conf->speed != SPEED_1000 &&
+		    conf->speed != SPEED_100 &&
+		    conf->speed != SPEED_10)
+			return sparx5_port_error(port, conf, SPX5_PERR_SPEED);
+		break;
 	default:
 		return sparx5_port_error(port, conf, SPX5_PERR_IFTYPE);
 	}

-- 
2.34.1