[PATCH] drm/mediatek: stop selecting foreign drivers

AngeloGioacchino Del Regno angelogioacchino.delregno at collabora.com
Wed Dec 18 02:50:17 PST 2024


Il 18/12/24 09:58, Arnd Bergmann ha scritto:
> From: Arnd Bergmann <arnd at arndb.de>
> 
> The PHY portion of the mediatek hdmi driver was originally part of
> the driver it self and later split out into drivers/phy, which a
> 'select' to keep the prior behavior.
> 
> However, this leads to build failures when the PHY driver cannot
> be built:
> 
> WARNING: unmet direct dependencies detected for PHY_MTK_HDMI
>    Depends on [n]: (ARCH_MEDIATEK || COMPILE_TEST [=y]) && COMMON_CLK [=y] && OF [=y] && REGULATOR [=n]
>    Selected by [m]:
>    - DRM_MEDIATEK_HDMI [=m] && HAS_IOMEM [=y] && DRM [=m] && DRM_MEDIATEK [=m]
> ERROR: modpost: "devm_regulator_register" [drivers/phy/mediatek/phy-mtk-hdmi-drv.ko] undefined!
> ERROR: modpost: "rdev_get_drvdata" [drivers/phy/mediatek/phy-mtk-hdmi-drv.ko] undefined!
> 
> The best option here is to just not select the phy driver and leave that
> up to the defconfig. Do the same for the other PHY and memory drivers
> selected here as well for consistency.
> 
> Fixes: a481bf2f0ca4 ("drm/mediatek: Separate mtk_hdmi_phy to an independent module")
> Signed-off-by: Arnd Bergmann <arnd at arndb.de>

The problem is - no PHY no party, it's not going to work without... but I get the
reasons behind this change.

Are we sure that we can't just add a `depends on PHY_MTK_xxxx` (or extend
depends on DRM_MEDIATEK && PHY_MTK_xxx)?

Cheers,
Angelo

> ---
>   drivers/gpu/drm/mediatek/Kconfig | 5 -----
>   1 file changed, 5 deletions(-)
> 
> diff --git a/drivers/gpu/drm/mediatek/Kconfig b/drivers/gpu/drm/mediatek/Kconfig
> index 1c2f56b75716..1d4f20a4f265 100644
> --- a/drivers/gpu/drm/mediatek/Kconfig
> +++ b/drivers/gpu/drm/mediatek/Kconfig
> @@ -15,9 +15,6 @@ config DRM_MEDIATEK
>   	select DRM_BRIDGE_CONNECTOR
>   	select DRM_MIPI_DSI
>   	select DRM_PANEL
> -	select MEMORY
> -	select MTK_SMI
> -	select PHY_MTK_MIPI_DSI
>   	select VIDEOMODE_HELPERS
>   	help
>   	  Choose this option if you have a Mediatek SoCs.
> @@ -28,7 +25,6 @@ config DRM_MEDIATEK
>   config DRM_MEDIATEK_DP
>   	tristate "DRM DPTX Support for MediaTek SoCs"
>   	depends on DRM_MEDIATEK
> -	select PHY_MTK_DP
>   	select DRM_DISPLAY_HELPER
>   	select DRM_DISPLAY_DP_HELPER
>   	select DRM_DISPLAY_DP_AUX_BUS
> @@ -39,6 +35,5 @@ config DRM_MEDIATEK_HDMI
>   	tristate "DRM HDMI Support for Mediatek SoCs"
>   	depends on DRM_MEDIATEK
>   	select SND_SOC_HDMI_CODEC if SND_SOC
> -	select PHY_MTK_HDMI
>   	help
>   	  DRM/KMS HDMI driver for Mediatek SoCs




More information about the linux-arm-kernel mailing list