[PATCH] ARM: dts: nxp: imx6qdl: add dr_mode to usbotg

[Hui Wang]

On 12/13/24 20:55, Xu Yang wrote:
> On Fri, Dec 13, 2024 at 07:25:32PM +0800, Hui Wang wrote:
>> On 12/13/24 16:17, Xu Yang wrote:
>>> Hi,
>>>
>>> On Thu, Dec 12, 2024 at 12:31:26PM +0800, Hui Wang wrote:
>>>> For the chipidea usb driver, if the dr_mode is not set, it will set
>>>> the device to otg mode by default, so here the dr_mode has not been
>>>> set for a long time. But some testcases need to parse the dr_mode from
>>>> DT and decide the follow-up test strategy, here set the dr_mode to otg
>>>> explicitly for QA's testcases.
>>> The dr_mode is board specific property, so we normally don't put it in
>>> dtsi file. Also, imx6qdl.dtsi is a common dtsi, therefore it's not a
>>> correct place. I wonder you don't set dr_mode in other dts file which
>>> include will imx6qdl.dtsi?
>> Yes, our QA reported this issue against the imx6q-sabresd board, I thought
>> dr_mode could be overwritten if board dts set the dr_mode, so this change
>> will not impact existing boards. But as you said "we normally don't put it
>> in dtsi file", I will move it to imx6q-sabresd.dts.
> Okay. You can move it to imx6qdl-sabresd.dtsi too. Then you can reuse
> &usbotg {}.

Yes, for sure.

Thanks,

Hui.

> Thanks,
> Xu Yang
>
>> Thanks,
>>
>> Hui.
>>
>>> Thanks,
>>> Xu Yang
>>>
>>>> Signed-off-by: Hui Wang <hui.wang at canonical.com>
>>>> ---
>>>>    arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi | 1 +
>>>>    1 file changed, 1 insertion(+)
>>>>
>>>> diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi
>>>> index d2200c9db25a..285fb7314a88 100644
>>>> --- a/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi
>>>> +++ b/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi
>>>> @@ -982,6 +982,7 @@ usbotg: usb at 2184000 {
>>>>    				clocks = <&clks IMX6QDL_CLK_USBOH3>;
>>>>    				fsl,usbphy = <&usbphy1>;
>>>>    				fsl,usbmisc = <&usbmisc 0>;
>>>> +				dr_mode = "otg";
>>>>    				ahb-burst-config = <0x0>;
>>>>    				tx-burst-size-dword = <0x10>;
>>>>    				rx-burst-size-dword = <0x10>;
>>>> -- 
>>>> 2.34.1
>>>>