[PATCH v1 7/8] ARM: dts: aspeed: system1: Mark GPIO line high/low

[Ninad Palsule]

From: NINAD PALSULE <ninadpalsule at us.ibm.com>

- Mark following GPIO lines as input high:
  - GPIOL4 (reset PCH registers)
  - GPIOL5 (reset portition of intel ME)
- Mark isolate errors from cpu1 gpio (GPIOO6) as active low output.
- The fan controller reset line should be active high.

Signed-off-by: Ninad Palsule <ninad at linux.ibm.com>
---
 .../dts/aspeed/aspeed-bmc-ibm-system1.dts     | 28 +++++++++++++++++++
 1 file changed, 28 insertions(+)

diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-system1.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-system1.dts
index ca2d4a292687..be0cd6152c61 100644
--- a/arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-system1.dts
+++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-system1.dts
@@ -383,6 +383,34 @@ &gpio0 {
 	/*X0-X7*/	"fpga-pgood","power-chassis-good","pch-pgood","","","","","",
 	/*Y0-Y7*/	"","","","","","","","",
 	/*Z0-Z7*/	"","","","","","","","";
+
+	rtc_reset {
+		gpio-hog;
+		gpios = <ASPEED_GPIO(L, 4) GPIO_ACTIVE_HIGH>;
+		input;
+		line-name = "RST_RTCRST_N";
+	};
+
+	srtc_reset {
+		gpio-hog;
+		gpios = <ASPEED_GPIO(L, 5) GPIO_ACTIVE_HIGH>;
+		input;
+		line-name = "RST_SRTCRST_N";
+	};
+
+	fan_controller_reset {
+		gpio-hog;
+		gpios = <ASPEED_GPIO(L, 6) GPIO_ACTIVE_HIGH>;
+		output-high;
+		line-name = "BMC_FAN_E3_SVC_PEX_INT_N";
+	};
+
+	isolate_errs_cpu1 {
+		gpio-hog;
+		gpios = <ASPEED_GPIO(O, 6) GPIO_ACTIVE_LOW>;
+		output-low;
+		line-name = "isolate_errs_cpu1";
+	};
 };
 
 &emmc_controller {
-- 
2.43.0