[PATCH] ARM: dts: nxp: imx6qdl: add dr_mode to usbotg

[Hui Wang]

On 12/13/24 16:17, Xu Yang wrote:
> Hi,
>
> On Thu, Dec 12, 2024 at 12:31:26PM +0800, Hui Wang wrote:
>> For the chipidea usb driver, if the dr_mode is not set, it will set
>> the device to otg mode by default, so here the dr_mode has not been
>> set for a long time. But some testcases need to parse the dr_mode from
>> DT and decide the follow-up test strategy, here set the dr_mode to otg
>> explicitly for QA's testcases.
> The dr_mode is board specific property, so we normally don't put it in
> dtsi file. Also, imx6qdl.dtsi is a common dtsi, therefore it's not a
> correct place. I wonder you don't set dr_mode in other dts file which
> include will imx6qdl.dtsi?

Yes, our QA reported this issue against the imx6q-sabresd board, I 
thought dr_mode could be overwritten if board dts set the dr_mode, so 
this change will not impact existing boards. But as you said "we 
normally don't put it in dtsi file", I will move it to imx6q-sabresd.dts.

Thanks,

Hui.

> Thanks,
> Xu Yang
>
>> Signed-off-by: Hui Wang <hui.wang at canonical.com>
>> ---
>>   arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi | 1 +
>>   1 file changed, 1 insertion(+)
>>
>> diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi
>> index d2200c9db25a..285fb7314a88 100644
>> --- a/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi
>> +++ b/arch/arm/boot/dts/nxp/imx/imx6qdl.dtsi
>> @@ -982,6 +982,7 @@ usbotg: usb at 2184000 {
>>   				clocks = <&clks IMX6QDL_CLK_USBOH3>;
>>   				fsl,usbphy = <&usbphy1>;
>>   				fsl,usbmisc = <&usbmisc 0>;
>> +				dr_mode = "otg";
>>   				ahb-burst-config = <0x0>;
>>   				tx-burst-size-dword = <0x10>;
>>   				rx-burst-size-dword = <0x10>;
>> -- 
>> 2.34.1
>>