[PATCH v3 0/2] thermal: imx91: Add support for i.MX91 thermal monitoring unit

[Frank Li]

- Add binding doc
- Add imx91 thermal driver
- dts part wait for https://lore.kernel.org/imx/Z04W5chGq5TitB9f@lizhi-Precision-Tower-5810/
merged, so not in this serial.

Signed-off-by: Frank Li <Frank.Li at nxp.com>
---
Changes in v3:
- add ref thermal-sensor
- restrict #thermal-sensor-cells to 0 only
- Change to unevaluatedProperties

- add IMX91_TMU_ prefix for register define
- remove unused register define
- fix missed pm_runtime_put() at error path in imx91_tmu_get_temp()
- use dev variable in probe function
- use pm_runtime_set_active() in probe
- move START to imx91_tmu_get_temp()
- use DEFINE_RUNTIME_DEV_PM_OPS()
- keep set reset value because there are not sw "reset" bit in controller,
  uboot may change and enable tmu.

- Link to v2: https://lore.kernel.org/r/20241210-imx91tmu-v2-0-5032aad4d88e@nxp.com

Changes in v2:
- use low case for hexvalue
- combine struct imx91_tmu and tmu_sensor
- simplify imx91_tmu_start() and imx91_tmu_enable()
- use s16 for imx91_tmu_get_temp(), which may negative value
- use reverse christmas tree style
- use run time pm
- use oneshot to sample temp
- register thermal zone after hardware init
- Link to v1: https://lore.kernel.org/r/20241209-imx91tmu-v1-0-7859c5387f31@nxp.com

---
Pengfei Li (2):
      dt-bindings: thermal: fsl,imx91-tmu: add bindings for NXP i.MX91 thermal module
      thermal: imx91: Add support for i.MX91 thermal monitoring unit

 .../devicetree/bindings/thermal/fsl,imx91-tmu.yaml |  67 ++++++
 drivers/thermal/Kconfig                            |  10 +
 drivers/thermal/Makefile                           |   1 +
 drivers/thermal/imx91_thermal.c                    | 263 +++++++++++++++++++++
 4 files changed, 341 insertions(+)
---
base-commit: d07c576946b2bc440d6d2073998023e8a0bd7568
change-id: 20241209-imx91tmu-af2a7c042d8d

Best regards,
---
Frank Li <Frank.Li at nxp.com>