[PATCH v3 0/3] drm/rockchip: Add driver for the new DSI2 controller

[Dmitry Baryshkov]

On Tue, Dec 10, 2024 at 08:50:51AM +0800, Andy Yan wrote:
> 
> 
> Hi,
> 
> At 2024-12-10 07:12:26, "Heiko Stübner" <heiko at sntech.de> wrote:
> >Am Montag, 9. Dezember 2024, 17:11:03 CET schrieb Diederik de Haas:
> >> Hi,
> >> 
> >> On Mon Dec 9, 2024 at 4:06 PM CET, Daniel Semkowicz wrote:
> >> > On 03.12.24 21:54, Heiko Stuebner wrote:
> >> > > This series adds a bridge and glue driver for the DSI2 controller found
> >> > > in the rk3588 soc from Rockchip, that is based on a Synopsis IP block.
> >> > > 
> >> >
> >> > I did more tests with different LVDS displays. I tested following
> >> > configurations with DSI/LVDS bridge:
> >> > - 1024x600 at 60.01
> >> > - 1024x768 at 60.02
> >> > - 1280x800 at 60.07
> >> > - 1366x768 at 60.06
> >> >
> >> > All of them worked without issues, except 1366x768.
> >> > With this resolution, video is blurry, and offset incorrectly
> >> > to the left. There are also repeating errors on the console:
> >> >
> >> >   rockchip-drm display-subsystem: [drm] *ERROR* POST_BUF_EMPTY irq err at vp3
> >> >
> >> > In correct operation with other resolutions, there is no error.
> >> > I am not sure if this is a problem in your series or rather in VOP2
> >> > driver.
> >
> >This really sounds like something is wrong on the vop side.
> >The interrupt is part of the vop, the divisable by 4 things likely too.
> 
> This is a hardware limitation on vop side:
> The horizontal resolution must be 4 pixel aligned.

Then mode_valid() and atomic_check() must reject modes that don't fit.

> 
> 
> 

-- 
With best wishes
Dmitry