[PATCH] spi: zynq-qspi: Add check for clk_enable()

[Mingwei Zheng]

Add check for the return value of clk_enable() to catch the potential
error.

Fixes: c618a90dcaf3 ("spi: zynq-qspi: Drop GPIO header")
Signed-off-by: Mingwei Zheng <zmw12306 at gmail.com>
Signed-off-by: Jiasheng Jiang <jiashengjiangcool at gmail.com>
---
 drivers/spi/spi-zynq-qspi.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-zynq-qspi.c b/drivers/spi/spi-zynq-qspi.c
index dee9c339a35e..ae8a955bb6f1 100644
--- a/drivers/spi/spi-zynq-qspi.c
+++ b/drivers/spi/spi-zynq-qspi.c
@@ -379,12 +379,18 @@ static int zynq_qspi_setup_op(struct spi_device *spi)
 {
 	struct spi_controller *ctlr = spi->controller;
 	struct zynq_qspi *qspi = spi_controller_get_devdata(ctlr);
+	int ret;
 
 	if (ctlr->busy)
 		return -EBUSY;
 
-	clk_enable(qspi->refclk);
-	clk_enable(qspi->pclk);
+	ret = clk_enable(qspi->refclk);
+	if (ret)
+		return ret;
+
+	ret = clk_enable(qspi->pclk);
+	if (ret)
+		return ret;
 	zynq_qspi_write(qspi, ZYNQ_QSPI_ENABLE_OFFSET,
 			ZYNQ_QSPI_ENABLE_ENABLE_MASK);
 
-- 
2.34.1