[PATCH 1/4] power: supply: add support for max77759 fuel gauge

[Thomas Antoine]

On 12/3/24 10:45, André Draszik wrote:
> On Tue, 2024-12-03 at 07:23 +0000, André Draszik wrote:
>> On Tue, 2024-12-03 at 06:47 +0000, André Draszik wrote:
>>> Hi Thomas,
>>>
>>> Thanks for looking into this!
>>>
>>>> From: Thomas Antoine <t.antoine at uclouvain.be>
>>>>
>>>> The Maxim max77759 fuel gauge has the same interface as the Maxim max1720x
>>>> except for the non-volatile memory slave address which is not available.
>>>
>>> It is not fully compatible, and it also has a lot more registers.
>>>
>>> For example, the voltage now is not in register 0xda as this driver assumes.
>>> With these changes, POWER_SUPPLY_PROP_VOLTAGE_NOW just reads as 0. 0xda
>>> doesn't exist in max77759
>>>
>>> I haven't compared in depth yet, though.
>>
>> Regarding the regmap in this driver, please see below comparison I had
>> collected some time ago:
>>
>> 	regmap_reg_range(0x24, 0x26), // exists
>> 	regmap_reg_range(0x30, 0x31), // exists
>> 	regmap_reg_range(0x33, 0x34), // exists
>> 	regmap_reg_range(0x37, 0x37), // exists
>> 	regmap_reg_range(0x3B, 0x3C), // exists
>> 	regmap_reg_range(0x40, 0x41), // exists
>> 	regmap_reg_range(0x43, 0x44), // exists
>> 	regmap_reg_range(0x47, 0x49), // exists
>> 	regmap_reg_range(0x4B, 0x4C), // exists
>> 	regmap_reg_range(0x4E, 0xAF), // 0x4e 0x4f exists
>> 	regmap_reg_range(0xB1, 0xB3), // exists
>> 	regmap_reg_range(0xB5, 0xB7), // exists
>> 	regmap_reg_range(0xBF, 0xD0), // 0xd0 exists
>> 	0xd1 .. 0xdb don't exist
>> 	regmap_reg_range(0xDB, 0xDB),
>> 	regmap_reg_range(0xE0, 0xFF), // 0xfb 0xff exist
>>
>> the comments refer to whether or not the register exists in max77759
> 
> I think this should make it more clear:
> allow:
> 	regmap_reg_range(0x00, 0xff),
> deny:
> 	regmap_reg_range(0x50, 0xaf),
> 	regmap_reg_range(0xc0, 0xcf),
> 	regmap_reg_range(0xd1, 0xdb),
> 	regmap_reg_range(0xe0, 0xfa),
> 	regmap_reg_range(0xfc, 0xfe),

Should I explicitly deny their use in the code for the max77759 or is it
just for information?

Best regards,
Thomas