[PATCH v1] thermal: brcmstb_thermal: Simplify with dev_err_probe()
Yan Zhen
yanzhen at vivo.com
Fri Aug 30 03:39:18 PDT 2024
dev_err_probe() is used to log an error message during the probe process
of a device.
It can simplify the error path and unify a message template.
Using this helper is totally fine even if err is known to never
be -EPROBE_DEFER.
The benefit compared to a normal dev_err() is the standardized format
of the error code, it being emitted symbolically and the fact that
the error code is returned which allows more compact error paths.
Signed-off-by: Yan Zhen <yanzhen at vivo.com>
---
drivers/thermal/broadcom/brcmstb_thermal.c | 15 ++++++---------
1 file changed, 6 insertions(+), 9 deletions(-)
diff --git a/drivers/thermal/broadcom/brcmstb_thermal.c b/drivers/thermal/broadcom/brcmstb_thermal.c
index 9674e5ffcfa2..270982740fde 100644
--- a/drivers/thermal/broadcom/brcmstb_thermal.c
+++ b/drivers/thermal/broadcom/brcmstb_thermal.c
@@ -338,11 +338,9 @@ static int brcmstb_thermal_probe(struct platform_device *pdev)
thermal = devm_thermal_of_zone_register(&pdev->dev, 0, priv,
of_ops);
- if (IS_ERR(thermal)) {
- ret = PTR_ERR(thermal);
- dev_err(&pdev->dev, "could not register sensor: %d\n", ret);
- return ret;
- }
+ if (IS_ERR(thermal))
+ return dev_err_probe(&pdev->dev, PTR_ERR(thermal),
+ "could not register sensor\n");
priv->thermal = thermal;
@@ -352,10 +350,9 @@ static int brcmstb_thermal_probe(struct platform_device *pdev)
brcmstb_tmon_irq_thread,
IRQF_ONESHOT,
DRV_NAME, priv);
- if (ret < 0) {
- dev_err(&pdev->dev, "could not request IRQ: %d\n", ret);
- return ret;
- }
+ if (ret < 0)
+ return dev_err_probe(&pdev->dev, ret,
+ "could not request IRQ\n");
}
dev_info(&pdev->dev, "registered AVS TMON of-sensor driver\n");
--
2.34.1
More information about the linux-arm-kernel
mailing list