[PATCH ethtool-next v2 0/3] Introduce PHY listing and targeting
Maxime Chevallier
maxime.chevallier at bootlin.com
Wed Aug 28 08:25:07 PDT 2024
Hello,
This series adds the ethtool-side support to list PHYs associated to a
netdevice, as well as allowing to target PHYs for some commands :
- PSE-PD commands
- Cable testing commands
- PLCA commands
This V2 uses the uAPI that got applied on the associated kernel-side
series [1], cleans a few lose-ends from the first version, and adds the
manpage modifications that was missing from V1.
The PHY-targetting commands look like this:
ethtool --phy 1 --cable-test eth0
Note that the --phy parameter gets passed at the beginning of the
command-line. This allows getting a generic command-line parsing code,
easy to write, but at the expense of maybe being a bit counter intuitive.
Another option could be to add a "phy" parameter to all the supported
commands, let me know if you think this looks too bad.
Patch 1 deals with the ability to pass a PHY index to the relevant
commands.
Patch 2 implements the --show-phys command. This command uses a netlink
DUMP request to list the PHYs, and introduces the ability to perform
filtered DUMP request, where the netdev index gets passed in the DUMP
request header.
Thanks,
Maxime
[1]: https://lore.kernel.org/netdev/20240821151009.1681151-1-maxime.chevallier@bootlin.com/
Link to V1: https://lore.kernel.org/netdev/20240103142950.235888-1-maxime.chevallier@bootlin.com/
Maxime Chevallier (3):
update UAPI header copies
ethtool: Allow passing a PHY index for phy-targetting commands
ethtool: Introduce a command to list PHYs
Makefile.am | 1 +
ethtool.8.in | 56 +++++++++++++++++
ethtool.c | 30 ++++++++-
internal.h | 1 +
netlink/cable_test.c | 4 +-
netlink/extapi.h | 1 +
netlink/msgbuff.c | 52 ++++++++++++----
netlink/msgbuff.h | 3 +
netlink/nlsock.c | 38 ++++++++++++
netlink/nlsock.h | 2 +
netlink/phy.c | 116 +++++++++++++++++++++++++++++++++++
netlink/plca.c | 4 +-
netlink/pse-pd.c | 4 +-
uapi/linux/ethtool.h | 16 +++++
uapi/linux/ethtool_netlink.h | 25 ++++++++
15 files changed, 334 insertions(+), 19 deletions(-)
create mode 100644 netlink/phy.c
--
2.45.2
More information about the linux-arm-kernel
mailing list