[PATCH v3] arm64: dts: imx8mm-emtop-baseboard: Add Peripherals Support

[Tarang Raval]

Hi Fabio,

Currently, the Ethernet cable is not connected, which is why it's showing that message.
If I connect the Ethernet cable, it will give a log like this:

[   12.670384] fec 30be0000.ethernet eth0: Link is Down
[   14.719222] fec 30be0000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx

Regards,
Tarang

________________________________________
From: Fabio Estevam <festevam at gmail.com>
Sent: Tuesday, August 27, 2024 5:40 PM
To: Tarang Raval <tarang.raval at siliconsignals.io>
Cc: Marc Kleine-Budde <mkl at pengutronix.de>; shawnguo at kernel.org <shawnguo at kernel.org>; krzk+dt at kernel.org <krzk+dt at kernel.org>; Rob Herring <robh at kernel.org>; Conor Dooley <conor+dt at kernel.org>; devicetree at vger.kernel.org <devicetree at vger.kernel.org>; Sascha Hauer <s.hauer at pengutronix.de>; linux-kernel at vger.kernel.org <linux-kernel at vger.kernel.org>; Pengutronix Kernel Team <kernel at pengutronix.de>; imx at lists.linux.dev <imx at lists.linux.dev>; linux-arm-kernel at lists.infradead.org <linux-arm-kernel at lists.infradead.org>
Subject: Re: [PATCH v3] arm64: dts: imx8mm-emtop-baseboard: Add Peripherals Support
 
CAUTION: This email originated from outside the organization. Do not click links or open attachments unless you recognize the sender and know the content is safe.

Hi Tarang,

On Tue, Aug 27, 2024 at 8:16 AM Tarang Raval
<tarang.raval at siliconsignals.io> wrote:

> [    8.639860] fec 30be0000.ethernet eth0: Unable to connect to phy
> [    8.708452] fec 30be0000.ethernet eth0: Unable to connect to phy

What about this network issue?