[PATCH 11/11] arm64: dts: rp1: Add support for MACB contained in RP1

[Florian Fainelli]

On 8/20/24 07:36, Andrea della Porta wrote:
> RaspberryPi RP1 is multi function PCI endpoint device that
> exposes several subperipherals via PCI BAR.
> Add an ethernet node for Cadence MACB to the RP1 dtso
> 
> Signed-off-by: Andrea della Porta <andrea.porta at suse.com>
> ---
>   arch/arm64/boot/dts/broadcom/rp1.dtso | 23 +++++++++++++++++++++++
>   1 file changed, 23 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/broadcom/rp1.dtso b/arch/arm64/boot/dts/broadcom/rp1.dtso
> index d80178a278ee..b40e203c28d5 100644
> --- a/arch/arm64/boot/dts/broadcom/rp1.dtso
> +++ b/arch/arm64/boot/dts/broadcom/rp1.dtso
> @@ -78,6 +78,29 @@ rp1_clocks: clocks at c040018000 {
>   							       <50000000>;   // RP1_CLK_ETH_TSU
>   				};
>   
> +				rp1_eth: ethernet at c040100000 {
> +					reg = <0xc0 0x40100000  0x0 0x4000>;
> +					compatible = "cdns,macb";
> +					#address-cells = <1>;
> +					#size-cells = <0>;
> +					interrupts = <RP1_INT_ETH IRQ_TYPE_LEVEL_HIGH>;
> +					clocks = <&macb_pclk &macb_hclk &rp1_clocks RP1_CLK_ETH_TSU>;
> +					clock-names = "pclk", "hclk", "tsu_clk";
> +					phy-mode = "rgmii-id";
> +					cdns,aw2w-max-pipe = /bits/ 8 <8>;
> +					cdns,ar2r-max-pipe = /bits/ 8 <8>;
> +					cdns,use-aw2b-fill;
> +					local-mac-address = [00 00 00 00 00 00];
> +					phy-handle = <&phy1>;
> +					phy-reset-gpios = <&rp1_gpio 32 GPIO_ACTIVE_LOW>;
> +					phy-reset-duration = <5>;
> +
> +					phy1: ethernet-phy at 1 {
> +						reg = <0x1>;
> +						brcm,powerdown-enable;

Undocumented property, and I would like to understand why this needs to 
be specified in the Device Tree? What model of Broadcom Ethernet PHY is 
being used here?
-- 
Florian