[PATCH v3 1/5] arm64: dts: ti: k3-j7200: Change timer nodes status to reserved
Beleswar Padhi
b-padhi at ti.com
Fri Aug 16 00:39:04 PDT 2024
The remoteproc firmware of R5F in the MAIN voltage domain use timers.
Therefore, change the status of the timer nodes to "reserved" to avoid
any clash. Usage is described as below:
+===================+==========================+
| Remoteproc node | Timer Node |
+===================+==========================+
| main_r5fss0_core0 | main_timer0, main_timer2 |
+-------------------+--------------------------+
| main_r5fss0_core1 | main_timer1 |
+-------------------+--------------------------+
Fixes: c8a28ed4837c ("arm64: dts: ti: k3-j7200: Add general purpose timers")
Signed-off-by: Beleswar Padhi <b-padhi at ti.com>
---
.../boot/dts/ti/k3-j7200-common-proc-board.dts | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
index 6593c5da82c0..a65066bd7f09 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
@@ -471,3 +471,16 @@ &main_mcan3 {
pinctrl-0 = <&main_mcan3_pins_default>;
phys = <&transceiver3>;
};
+
+/* Timers are used by Remoteproc firmware */
+&main_timer0 {
+ status = "reserved";
+};
+
+&main_timer1 {
+ status = "reserved";
+};
+
+&main_timer2 {
+ status = "reserved";
+};
--
2.34.1
More information about the linux-arm-kernel
mailing list