[PATCH 3/3] arm64: dts: sprd: sc2731: move fuel-gauge monitored-battery to device DTS

[Stanislav Jakubek]

The monitored-battery property is a property of the board, not the PMIC.
Move this property to the DTS of its only user, sp9860g-1h10.
While at it, disable the fuel-gauge node by default and enable it only
for its users, as it requires board-specific properties to work correctly.

Signed-off-by: Stanislav Jakubek <stano.jakubek at gmail.com>
---
Note that the 'sprd,calib-resistance-micro-ohms' property isn't specified
as I do not have the board or any other source of information about it.

If the SPRD folks could chime in here, that'd be great.

 arch/arm64/boot/dts/sprd/sc2731.dtsi      | 4 ++--
 arch/arm64/boot/dts/sprd/sp9860g-1h10.dts | 5 +++++
 2 files changed, 7 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/sprd/sc2731.dtsi b/arch/arm64/boot/dts/sprd/sc2731.dtsi
index c8b30c0479fd..0eb4aca0a139 100644
--- a/arch/arm64/boot/dts/sprd/sc2731.dtsi
+++ b/arch/arm64/boot/dts/sprd/sc2731.dtsi
@@ -94,17 +94,17 @@ pmic_adc: adc at 480 {
 			nvmem-cells = <&adc_big_scale>, <&adc_small_scale>;
 		};
 
-		fuel-gauge at a00 {
+		pmic_fgu: fuel-gauge at a00 {
 			compatible = "sprd,sc2731-fgu";
 			reg = <0xa00>;
 			bat-detect-gpios = <&pmic_eic 9 GPIO_ACTIVE_HIGH>;
 			io-channels = <&pmic_adc 3>, <&pmic_adc 6>;
 			io-channel-names = "bat-temp", "charge-vol";
-			monitored-battery = <&bat>;
 			nvmem-cell-names = "fgu_calib";
 			nvmem-cells = <&fgu_calib>;
 			interrupt-parent = <&sc2731_pmic>;
 			interrupts = <4>;
+			status = "disabled";
 		};
 
 		vibrator at ec8 {
diff --git a/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts b/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts
index cd8b1069e387..a5f6acafee3a 100644
--- a/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts
+++ b/arch/arm64/boot/dts/sprd/sp9860g-1h10.dts
@@ -84,6 +84,11 @@ bat: battery {
 	};
 };
 
+&pmic_fgu {
+	monitored-battery = <&bat>;
+	status = "okay";
+};
+
 &uart0 {
 	status = "okay";
 };
-- 
2.34.1