[PATCH v2 1/5] arm64: dts: ti: k3-j7200: Change timer nodes status to reserved

Kumar, Udit u-kumar1 at ti.com
Wed Aug 14 08:11:49 PDT 2024


On 8/14/2024 4:11 PM, Beleswar Padhi wrote:
> The remoteproc firmware like of R5F and DSPs in the MAIN voltage domain

There is no DSP on this SOC.

Please consider to re-word commit message


> use timers. Therefore, change the status of the timer nodes to
> "reserved" to avoid any clash. Usage is described as below:
>
> 	+===================+==========================+
> 	|  Remoteproc node  |        Timer Node        |
> 	+===================+==========================+
> 	| main_r5fss0_core0 | main_timer0, main_timer2 |
> 	+-------------------+--------------------------+
> 	| main_r5fss0_core1 | main_timer1              |
> 	+-------------------+--------------------------+


> This change is already incorporated for timer nodes in the MCU voltage
> domain.

For whole series,  on MCU domain R5 we have device-manager firmware,

which is needed to get SOC functional. So MCU domain timers are reserved.

So my suggestion will be to avoid above message


>
> Fixes: c8a28ed4837c ("arm64: dts: ti: k3-j7200: Add general purpose timers")
> Signed-off-by: Beleswar Padhi <b-padhi at ti.com>
> ---
>   .../boot/dts/ti/k3-j7200-common-proc-board.dts      | 13 +++++++++++++
>   1 file changed, 13 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
> index 6593c5da82c0..a65066bd7f09 100644
> --- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
> +++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
> @@ -471,3 +471,16 @@ &main_mcan3 {
>   	pinctrl-0 = <&main_mcan3_pins_default>;
>   	phys = <&transceiver3>;
>   };
> +
> +/* Timers are used by Remoteproc firmware */
> +&main_timer0 {
> +	status = "reserved";
> +};
> +
> +&main_timer1 {
> +	status = "reserved";
> +};
> +
> +&main_timer2 {
> +	status = "reserved";
> +};



More information about the linux-arm-kernel mailing list