[PATCH net-next v17 08/14] netlink: specs: add ethnl PHY_GET command set

[Christophe Leroy]

Le 09/07/2024 à 08:30, Maxime Chevallier a écrit :
> The PHY_GET command, supporting both DUMP and GET operations, is used to
> retrieve the list of PHYs connected to a netdevice, and get topology
> information to know where exactly it sits on the physical link.
> 
> Add the netlink specs corresponding to that command.
> 
> Signed-off-by: Maxime Chevallier <maxime.chevallier at bootlin.com>

Reviewed-by: Christophe Leroy <christophe.leroy at csgroup.eu>
Tested-by: Christophe Leroy <christophe.leroy at csgroup.eu>

> ---
>   Documentation/netlink/specs/ethtool.yaml | 55 ++++++++++++++++++++++++
>   1 file changed, 55 insertions(+)
> 
> diff --git a/Documentation/netlink/specs/ethtool.yaml b/Documentation/netlink/specs/ethtool.yaml
> index 586f1da8eb7b..d96a8050172b 100644
> --- a/Documentation/netlink/specs/ethtool.yaml
> +++ b/Documentation/netlink/specs/ethtool.yaml
> @@ -39,6 +39,11 @@ definitions:
>           - ovld-detected
>           - power-not-available
>           - short-detected
> +  -
> +    name: phy-upstream-type
> +    enum-name:
> +    type: enum
> +    entries: [ mac, phy ]
>   
>   attribute-sets:
>     -
> @@ -1088,6 +1093,35 @@ attribute-sets:
>         -
>           name: total
>           type: uint
> +  -
> +    name: phy
> +    attributes:
> +      -
> +        name: header
> +        type: nest
> +        nested-attributes: header
> +      -
> +        name: index
> +        type: u32
> +      -
> +        name: drvname
> +        type: string
> +      -
> +        name: name
> +        type: string
> +      -
> +        name: upstream-type
> +        type: u32
> +        enum: phy-upstream-type
> +      -
> +        name: upstream-index
> +        type: u32
> +      -
> +        name: upstream-sfp-name
> +        type: string
> +      -
> +        name: downstream-sfp-name
> +        type: string
>   
>   operations:
>     enum-model: directional
> @@ -1880,3 +1914,24 @@ operations:
>             - status-msg
>             - done
>             - total
> +    -
> +      name: phy-get
> +      doc: Get PHY devices attached to an interface
> +
> +      attribute-set: phy
> +
> +      do: &phy-get-op
> +        request:
> +          attributes:
> +            - header
> +        reply:
> +          attributes:
> +            - header
> +            - index
> +            - drvname
> +            - name
> +            - upstream-type
> +            - upstream-index
> +            - upstream-sfp-name
> +            - downstream-sfp-name
> +      dump: *phy-get-op