[PATCH v5 10/12] PCI: brcmstb: Check return value of all reset_control_xxx calls

[Manivannan Sadhasivam]

On Wed, Jul 31, 2024 at 06:28:24PM -0400, Jim Quinlan wrote:
> Always check the return value for invocations of reset_control_xxx() and
> propagate the error to the next level.  Although the current functions
> in reset-brcmstb.c cannot fail, this may someday change.
> 
> Signed-off-by: Jim Quinlan <james.quinlan at broadcom.com>

One comment below. With that addressed,

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>

> Reviewed-by: Stanimir Varbanov <svarbanov at suse.de>
> Reviewed-by: Florian Fainelli <florian.fainelli at broadcom.com>
> ---
>  drivers/pci/controller/pcie-brcmstb.c | 102 ++++++++++++++++++--------
>  1 file changed, 73 insertions(+), 29 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
> index 0ecca3d9576f..c4ceb1823a79 100644
> --- a/drivers/pci/controller/pcie-brcmstb.c
> +++ b/drivers/pci/controller/pcie-brcmstb.c

[...]

>  static int pci_dev_may_wakeup(struct pci_dev *dev, void *data)
> @@ -1478,9 +1514,12 @@ static int brcm_pcie_suspend_noirq(struct device *dev)
>  {
>  	struct brcm_pcie *pcie = dev_get_drvdata(dev);
>  	struct pci_host_bridge *bridge = pci_host_bridge_from_priv(pcie);
> -	int ret;
> +	int ret, rret;
> +
> +	ret = brcm_pcie_turn_off(pcie);
> +	if (ret)
> +		return ret;
>  
> -	brcm_pcie_turn_off(pcie);
>  	/*
>  	 * If brcm_phy_stop() returns an error, just dev_err(). If we
>  	 * return the error it will cause the suspend to fail and this is a
> @@ -1509,7 +1548,10 @@ static int brcm_pcie_suspend_noirq(struct device *dev)
>  						     pcie->sr->supplies);
>  			if (ret) {
>  				dev_err(dev, "Could not turn off regulators\n");
> -				reset_control_reset(pcie->rescal);
> +				rret = reset_control_reset(pcie->rescal);
> +				if (rret)
> +					dev_err(dev, "failed to reset 'rascal' controller ret=%d\n",
> +						rret);

I don't think it is really necessary to capture the return value in err path.
Unable to turn off the regulator itself is fatal, so we could just assert reset
and hope for the best.

- Mani

-- 
மணிவண்ணன் சதாசிவம்