[PATCH v3 5/5] arm64: dts: ti: k3-j7200*: Add bootph-* properties

Kumar, Udit u-kumar1 at ti.com
Wed Aug 7 02:15:24 PDT 2024


On 8/7/2024 1:20 PM, Manorit Chawdhry wrote:
> Hi Udit,
>
> On 12:58-20240807, Kumar, Udit wrote:
>> On 7/30/2024 3:23 PM, Manorit Chawdhry wrote:
>>> [..]
>>> I think you should consider to mark hbmc node for boot phase as well
>>>
> It's already marked in k3-j7200-som-p0.dtsi file with bootph-all inside
> the flash node that describe it, is that okay?


yes

>
>>> @@ -652,6 +661,7 @@ wkup_vtm0: temperature-sensor at 42040000 {
>>>    		      <0x00 0x42050000 0x00 0x350>;
>>>    		power-domains = <&k3_pds 154 TI_SCI_PD_EXCLUSIVE>;
>>>    		#thermal-sensor-cells = <1>;
>>> +		bootph-pre-ram;
>>>    	};
>>>    	mcu_esm: esm at 40800000 {
>>> diff --git a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>>> index 21fe194a5766..d78f86889bf9 100644
>>> --- a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>>> +++ b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>>> @@ -121,6 +121,7 @@ J721E_WKUP_IOPAD(0x20, PIN_INPUT, 1) /* (B8) MCU_OSPI0_D5.MCU_HYPERBUS0_DQ5 */
>>>    			J721E_WKUP_IOPAD(0x24, PIN_INPUT, 1) /* (A8) MCU_OSPI0_D6.MCU_HYPERBUS0_DQ6 */
>>>    			J721E_WKUP_IOPAD(0x28, PIN_INPUT, 1) /* (A7) MCU_OSPI0_D7.MCU_HYPERBUS0_DQ7 */
>>>    		>;
>>> [..]
>>>    			bucka2: buck2 {
>>> @@ -464,6 +470,7 @@ flash at 0 {
>>>    		cdns,tchsh-ns = <60>;
>>>    		cdns,tslch-ns = <60>;
>>>    		cdns,read-delay = <4>;
>>> +		bootph-all;
>>>    		partitions {
>>>    			compatible = "fixed-partitions";
>>
>> Please consider, adding bootph in ospi0 node as well around
>> "ospi.phypattern"
>>
> Okay sure, will move the bootph-all from flash at 0 node to under
> ospi.phypattern node as putting it in the child node should propagate
> it.
>
> Thanks for reviewing Udit!
>
> Regards,
> Manorit



More information about the linux-arm-kernel mailing list