[PATCH v3 2/3] Bluetooth: hci_uart: Add support for Amlogic HCI UART

[Krzysztof Kozlowski]

On 06/08/2024 10:33, Yang Li wrote:
> 
> On 2024/8/6 1:29, Krzysztof Kozlowski wrote:
>> On 02/08/2024 11:39, Yang Li via B4 Relay wrote:
>>> From: Yang Li <yang.li at amlogic.com>
>>>
>> ...
>>
>>> +
>>> +static const struct aml_device_data data_w155s2 = {
>>> +     .iccm_offset = 256 * 1024,
>>> +};
>>> +
>>> +static const struct aml_device_data data_w265s2 = {
>>> +     .iccm_offset = 384 * 1024,
>>> +};
>>> +
>>> +static const struct of_device_id aml_bluetooth_of_match[] = {
>>> +     { .compatible = "amlogic,w155s2-bt", .data = &data_w155s2 },
>>> +     { .compatible = "amlogic,w265s2-bt", .data = &data_w265s2 },
>> Your binding says these devices are compatible, but above suggests it is
>> not. Confusing.
> 
> Yes, the DT binding is incorrect. I will refer to 
> broadcom-bluetooth.yaml to make the modifications as follows:
> 
> properties:
>    compatible:
>      oneOf:
>        - items:
>            - enum:
>                - amlogic,w265s1-bt
>                - amlogic,w265p1-bt
>            - const: amlogic,w155s2-bt
>        - enum:
>            - amlogic,w155s2-bt
>            - amlogic,w265s2-bt
> 
> Please let me know if these changes are acceptable or if there are any 
> further adjustments needed.

Looks good, just please check which devices are compatible with which.

Best regards,
Krzysztof