[PATCH v5 1/5] firmware: arm_scmi: Remove superfluous handle_to_scmi_info

[Sudeep Holla]

From: Luke Parkin <luke.parkin at arm.com>

Variable info is already defined in the outer code block and there is no
need to define the same again in the inner code block. Let us just remove
that duplicate definition of the variable info. No functional change.

Reviewed-by: Cristian Marussi <cristian.marussi at arm.com>
Signed-off-by: Luke Parkin <luke.parkin at arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla at arm.com>
---
 drivers/firmware/arm_scmi/driver.c | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c
index 6b6957f4743f..56a93d20bf23 100644
--- a/drivers/firmware/arm_scmi/driver.c
+++ b/drivers/firmware/arm_scmi/driver.c
@@ -1261,9 +1261,6 @@ static int scmi_wait_for_reply(struct device *dev, const struct scmi_desc *desc,
 					    xfer->rx.buf, xfer->rx.len);
 
 			if (IS_ENABLED(CONFIG_ARM_SCMI_RAW_MODE_SUPPORT)) {
-				struct scmi_info *info =
-					handle_to_scmi_info(cinfo->handle);
-
 				scmi_raw_message_report(info->raw, xfer,
 							SCMI_RAW_REPLY_QUEUE,
 							cinfo->id);
-- 
2.46.0