[PATCH net-next] net: dsa: mt7530: detect PHY muxing when PHY is defined on switch MDIO bus

[Arınç ÜNAL via B4 Relay]

From: Arınç ÜNAL <arinc.unal at arinc9.com>

Currently, the MT7530 DSA subdriver configures the MT7530 switch to provide
direct access to switch PHYs, meaning, the switch PHYs listen on the MDIO
bus the switch listens on. The PHY muxing feature makes use of this.

This is problematic as the PHY may be probed before the switch is
initialised, in which case attaching the PHY will fail.

Since commit 91374ba537bd ("net: dsa: mt7530: support OF-based registration
of switch MDIO bus"), we can describe the switch PHYs on the MDIO bus of
the switch on the device tree. Extend the check to detect PHY muxing when
the PHY is defined on the MDIO bus of the switch on the device tree.

When the PHY is described this way, the switch will be initialised first,
then the switch MDIO bus will be registered. Only after these steps, the
PHY will be probed.

Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
---
 drivers/net/dsa/mt7530.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index 2b9f904a98f0..6cf21c9d523b 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -2483,7 +2483,8 @@ mt7530_setup(struct dsa_switch *ds)
 			if (!phy_node)
 				continue;
 
-			if (phy_node->parent == priv->dev->of_node->parent) {
+			if (phy_node->parent == priv->dev->of_node->parent ||
+			    phy_node->parent->parent == priv->dev->of_node) {
 				ret = of_get_phy_mode(mac_np, &interface);
 				if (ret && ret != -ENODEV) {
 					of_node_put(mac_np);

---
base-commit: 5c4c0edca68a5841a8d53ccd49596fe199c8334c
change-id: 20240429-b4-for-netnext-mt7530-use-switch-mdio-bus-for-phy-muxing-586269371c55

Best regards,
-- 
Arınç ÜNAL <arinc.unal at arinc9.com>