[PATCH v3 4/4] arm64: dts: add description for solidrun cn9131 solidwan board

[Andrew Lunn]

On Fri, Apr 26, 2024 at 06:51:02PM +0000, Josua Mayer wrote:
> Am 26.04.24 um 20:18 schrieb Andrew Lunn:
> >>>> Colours are similar to RJ45 connectors (yellow, green),
> >>>> and are intended for the same purpose: link, activity.
> >>> For the switch LEDs you used label = "LED10"; Does the silk screen
> >>> have similar numbers for these LEDs?
> >> Correct, on CN9130 Clearfog Pro DSA switch, all LEDs are labeled
> >> individually on the silk screen.
> >>
> >> The SolidWAN SFP leds are dual-colour leds with 3 terminals:
> >> anode to 3.3V, 2x cathode to gpio-controlled transistors.
> >> They are labeled on the silk-screen as "LED9", "LED10".
> >>
> >> Duplicate labels are not great, is there a better way?
> >> old style "LED9:green" e.g. ...?
> > So you have copper LEDs and SFP LEDs, each with the same silk screen
> > label? Maybe put 'copper' and 'sfp' as a prefix into the label?
> 
> No, not quite.
> 
> We have 2x SFP Connectors.
> On the bottom side of PCB immediately below each connector is
> a single LED (as in physical component), each with a silk-screen label.
> 
> "J28"/"SFP 0": "LED10"
> "J42"/"SFP 1": "LED9"
> 
> The problem is that these leds are each two leds in single-package,

Ah! Sorry, you clearly said they were dual-colour.

> which is why I put 4 led nodes in dts, two labeled "sfp-0",
> other two "sfp-1".
> But I don't think this duplication of label in dts is a good idea.

Agreed. Then i would use the colour as a postfix.

	Andrew