[PATCH v8 11/16] irqchip/gic-v3: Add support for ACPI's disabled but 'online capable' CPUs

Fri Apr 26 09:26:09 PDT 2024

On Fri, 26 Apr 2024 14:51:21 +0100,
Jonathan Cameron <Jonathan.Cameron at huawei.com> wrote:
> 
> From: James Morse <james.morse at arm.com>
> 
> To support virtual CPU hotplug, ACPI has added an 'online capable' bit
> to the MADT GICC entries. This indicates a disabled CPU entry may not
> be possible to online via PSCI until firmware has set enabled bit in
> _STA.
> 
> This means that a "usable" GIC is one that is marked as either enabled,

nit: "GIC" usually designs the whole HW infrastructure (distributor,
redistributors, and ITSs). My understanding is that you are only
referring to the redistributors.

> or online capable. Therefore, change acpi_gicc_is_usable() to check both
> bits. However, we need to change the test in gic_acpi_match_gicc() back
> to testing just the enabled bit so the count of enabled distributors is
> correct.
> 
> What about the redistributor in the GICC entry? ACPI doesn't want to say.
> Assume the worst: When a redistributor is described in the GICC entry,
> but the entry is marked as disabled at boot, assume the redistributor
> is inaccessible.
> 
> The GICv3 driver doesn't support late online of redistributors, so this
> means the corresponding CPU can't be brought online either.
> Rather than modifying cpu masks that may already have been used,
> register a new cpuhp callback to fail this case. This must run earlier
> than the main gic_starting_cpu() so that this case can be rejected
> before the section of cpuhp that runs on the CPU that is coming up as
> that is not allowed to fail. This solution keeps the handling of this
> broken firmware corner case local to the GIC driver. As precise ordering
> of this callback doesn't need to be controlled as long as it is
> in that initial prepare phase, use CPUHP_BP_PREPARE_DYN.
> 
> Systems that want CPU hotplug in a VM can ensure their redistributors
> are always-on, and describe them that way with a GICR entry in the MADT.
> 
> Suggested-by: Marc Zyngier <maz at kernel.org>
> Signed-off-by: James Morse <james.morse at arm.com>
> Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
> Tested-by: Miguel Luis <miguel.luis at oracle.com>
> Co-developed-by: Jonathan Cameron <Jonathan.Cameron at huawei.com>
> Signed-off-by: Jonathan Cameron <Jonathan.Cameron at huawei.com>
> 
> ---
> Thanks to Marc for review and suggestions!
> v8: Change the handling of broken rdists to fail cpuhp rather than
>     modifying the cpu_present and cpu_possible masks.
>     Updated commit text to reflect that.
>     Added a sb tag for Marc given this is more or less what he put
>     in his review comment.
> ---
>  drivers/irqchip/irq-gic-v3.c | 38 ++++++++++++++++++++++++++++++++++--
>  include/linux/acpi.h         |  3 ++-
>  2 files changed, 38 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/irqchip/irq-gic-v3.c b/drivers/irqchip/irq-gic-v3.c
> index 10af15f93d4d..b4685991953e 100644
> --- a/drivers/irqchip/irq-gic-v3.c
> +++ b/drivers/irqchip/irq-gic-v3.c
> @@ -44,6 +44,8 @@
>  
>  #define GIC_IRQ_TYPE_PARTITION	(GIC_IRQ_TYPE_LPI + 1)
>  
> +static struct cpumask broken_rdists __read_mostly;
> +
>  struct redist_region {
>  	void __iomem		*redist_base;
>  	phys_addr_t		phys_base;
> @@ -1293,6 +1295,18 @@ static void gic_cpu_init(void)
>  #define MPIDR_TO_SGI_RS(mpidr)	(MPIDR_RS(mpidr) << ICC_SGI1R_RS_SHIFT)
>  #define MPIDR_TO_SGI_CLUSTER_ID(mpidr)	((mpidr) & ~0xFUL)
>  
> +/*
> + * gic_starting_cpu() is called after the last point where cpuhp is allowed
> + * to fail. So pre check for problems earlier.
> + */
> +static int gic_check_rdist(unsigned int cpu)
> +{
> +	if (cpumask_test_cpu(cpu, &broken_rdists))
> +		return -EINVAL;
> +
> +	return 0;
> +}
> +
>  static int gic_starting_cpu(unsigned int cpu)
>  {
>  	gic_cpu_init();
> @@ -1384,6 +1398,10 @@ static void __init gic_smp_init(void)
>  	};
>  	int base_sgi;
>  
> +	cpuhp_setup_state_nocalls(CPUHP_BP_PREPARE_DYN,
> +				  "irqchip/arm/gicv3:checkrdist",
> +				  gic_check_rdist, NULL);
> +
>  	cpuhp_setup_state_nocalls(CPUHP_AP_IRQ_GIC_STARTING,
>  				  "irqchip/arm/gicv3:starting",
>  				  gic_starting_cpu, NULL);
> @@ -2363,11 +2381,24 @@ gic_acpi_parse_madt_gicc(union acpi_subtable_headers *header,
>  				(struct acpi_madt_generic_interrupt *)header;
>  	u32 reg = readl_relaxed(acpi_data.dist_base + GICD_PIDR2) & GIC_PIDR2_ARCH_MASK;
>  	u32 size = reg == GIC_PIDR2_ARCH_GICv4 ? SZ_64K * 4 : SZ_64K * 2;
> +	int cpu = get_cpu_for_acpi_id(gicc->uid);
>  	void __iomem *redist_base;
>  
>  	if (!acpi_gicc_is_usable(gicc))
>  		return 0;
>  
> +	/*
> +	 * Capable but disabled CPUs can be brought online later. What about
> +	 * the redistributor? ACPI doesn't want to say!
> +	 * Virtual hotplug systems can use the MADT's "always-on" GICR entries.
> +	 * Otherwise, prevent such CPUs from being brought online.
> +	 */
> +	if (!(gicc->flags & ACPI_MADT_ENABLED)) {

Now this makes the above acpi_gicc_is_usable() very odd. It checks for
MADT_ENABLED *or* GICC_ONLINE_CAPABLE. But we definitely don't want to
deal with the lack of MADT_ENABLED.

So why don't we explicitly check for individual flags and get rid of
acpi_gicc_is_usable(), as its new definition doesn't tell you anything
useful?

> +		pr_warn_once("CPU %u's redistributor is inaccessible: this CPU can't be brought online\n", cpu);
> +		cpumask_set_cpu(cpu, &broken_rdists);

Given that get_cpu_for_acpi_id() can return -EINVAL, you'd want to
check that. Also, I'd like to drop the _once on the warning.
Indicating all the broken CPUs is useful information, and only happens
once per boot.

> +		return 0;
> +	}
> +
>  	redist_base = ioremap(gicc->gicr_base_address, size);
>  	if (!redist_base)
>  		return -ENOMEM;
> @@ -2413,9 +2444,12 @@ static int __init gic_acpi_match_gicc(union acpi_subtable_headers *header,
>  
>  	/*
>  	 * If GICC is enabled and has valid gicr base address, then it means
> -	 * GICR base is presented via GICC
> +	 * GICR base is presented via GICC. The redistributor is only known to
> +	 * be accessible if the GICC is marked as enabled. If this bit is not
> +	 * set, we'd need to add the redistributor at runtime, which isn't
> +	 * supported.
>  	 */
> -	if (acpi_gicc_is_usable(gicc) && gicc->gicr_base_address)
> +	if (gicc->flags & ACPI_MADT_ENABLED && gicc->gicr_base_address)
>  		acpi_data.enabled_rdists++;
>  
>  	return 0;
> diff --git a/include/linux/acpi.h b/include/linux/acpi.h
> index 9844a3f9c4e5..fcfb7bb6789e 100644
> --- a/include/linux/acpi.h
> +++ b/include/linux/acpi.h
> @@ -239,7 +239,8 @@ void acpi_table_print_madt_entry (struct acpi_subtable_header *madt);
>  
>  static inline bool acpi_gicc_is_usable(struct acpi_madt_generic_interrupt *gicc)
>  {
> -	return gicc->flags & ACPI_MADT_ENABLED;
> +	return gicc->flags & (ACPI_MADT_ENABLED |
> +			      ACPI_MADT_GICC_ONLINE_CAPABLE);
>  }
>  
>  /* the following numa functions are architecture-dependent */

Thanks,

	M.

-- 
Without deviation from the norm, progress is not possible.