[PATCH v2 10/11] ARM: dts: stm32: add ethernet1 and ethernet2 for STM32MP135F-DK board

[Marek Vasut]

On 4/26/24 2:57 PM, Christophe Roullier wrote:
> Add dual Ethernet:
> -Ethernet1: RMII with crystal
> -Ethernet2: RMII without crystal
> PHYs used are SMSC (LAN8742A)
> 
> With Ethernet1, we can performed WoL from PHY instead of GMAC point
> of view.
> (in this case IRQ for WoL is managed as wakeup pin and configured
> in OS secure).

How does the Linux PHY driver process such a PHY IRQ ?

Or is Linux unaware of the PHY IRQ ? Doesn't that cause issues ?

> diff --git a/arch/arm/boot/dts/st/stm32mp135f-dk.dts b/arch/arm/boot/dts/st/stm32mp135f-dk.dts
> index 567e53ad285f..3b8eb0ab9ab9 100644
> --- a/arch/arm/boot/dts/st/stm32mp135f-dk.dts
> +++ b/arch/arm/boot/dts/st/stm32mp135f-dk.dts
> @@ -19,6 +19,8 @@ / {
>   	compatible = "st,stm32mp135f-dk", "st,stm32mp135";
>   
>   	aliases {
> +		ethernet0 = &ethernet1;
> +		ethernet1 = &ethernet2;
>   		serial0 = &uart4;
>   		serial1 = &usart1;
>   		serial2 = &uart8;
> @@ -141,6 +143,52 @@ &cryp {
>   	status = "okay";
>   };
>   
> +&ethernet1 {
> +	status = "okay";
> +	pinctrl-0 = <&eth1_rmii_pins_a>;
> +	pinctrl-1 = <&eth1_rmii_sleep_pins_a>;
> +	pinctrl-names = "default", "sleep";
> +	phy-mode = "rmii";
> +	max-speed = <100>;
> +	phy-handle = <&phy0_eth1>;

Keep the list sorted please (is the max-speed even needed? if not, drop it)

> +	mdio {
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +		compatible = "snps,dwmac-mdio";
> +
> +		phy0_eth1: ethernet-phy at 0 {
> +			compatible = "ethernet-phy-id0007.c131";
> +			reset-gpios =  <&mcp23017 9 GPIO_ACTIVE_LOW>;
> +			reg = <0>;
> +			wakeup-source;
> +		};
> +	};
> +};
> +
> +&ethernet2 {
> +	status = "okay";
> +	pinctrl-0 = <&eth2_rmii_pins_a>;
> +	pinctrl-1 = <&eth2_rmii_sleep_pins_a>;
> +	pinctrl-names = "default", "sleep";
> +	phy-mode = "rmii";
> +	max-speed = <100>;
> +	phy-handle = <&phy0_eth2>;
> +	st,ext-phyclk;
> +	phy-supply = <&scmi_v3v3_sw>;

Sort please

[...]