[PATCH 4/4] arm: dts: allwinner: drop underscore in node names

Krzysztof Kozlowski krzysztof.kozlowski at linaro.org
Tue Apr 23 21:41:56 PDT 2024


On 23/04/2024 23:23, Rob Herring wrote:
> On Sun, Mar 17, 2024 at 1:41 PM Krzysztof Kozlowski
> <krzysztof.kozlowski at linaro.org> wrote:
>>
>> Underscores should not be used in node names (dtc with W=2 warns about
>> them), so replace them with hyphens.  Use also generic name for pwrseq
>> node, because generic naming is favored by Devicetree spec.  All the
>> clocks affected by this change use clock-output-names, so resulting
>> clock name should not change.  Functional impact checked with comparing
>> before/after DTBs with dtx_diff and fdtdump.
>>
>> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
> 
> This adds warnings:
> 
> 13  prcm at 1f01400: 'ahb0-clk', 'apb0-clk', 'apb0-gates-clk',
> 'apb0-rst', 'ar100-clk', 'ir-clk' do not match any of the regexes:
> '^.*_(clk|rst)$', 'pinctrl-[0-9]+'
> 
> Since we documented it with underscores, I'd say just leave these at
> least until if/when we define some standard names. I'd prefer we spend
> time reducing warnings from the common schema. I'm looking at
> root-node.yaml. simple-bus.yaml generates a lot too.

Uh, this was already picked up. I will send patch for schema, thanks for
the report.

Best regards,
Krzysztof




More information about the linux-arm-kernel mailing list