[PATCH net-next 07/13] net: dsa: mt7530: move MT753X_MTRAP operations for MT7530

Arınç ÜNAL via B4 Relay devnull+arinc.unal.arinc9.com at kernel.org
Fri Apr 19 03:09:30 PDT 2024


From: Arınç ÜNAL <arinc.unal at arinc9.com>

On MT7530, the media-independent interfaces of port 5 and 6 are controlled
by the MT7530_P5_DIS and MT7530_P6_DIS bits of the hardware trap. Deal with
these bits only when the relevant port is being enabled or disabled. This
ensures that these ports will be disabled when they are not in use.

Do not set MT7530_CHG_TRAP on mt7530_setup_port5() as that's already being
done on mt7530_setup().

Instead of globally setting MT7530_P5_MAC_SEL, clear it, then set it only
on the appropriate case.

If PHY muxing is detected, clear MT7530_P5_DIS before calling
mt7530_setup_port5().

Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
---
 drivers/net/dsa/mt7530.c | 38 +++++++++++++++++++++++++++-----------
 1 file changed, 27 insertions(+), 11 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index 606516206fb9..83436723cb16 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -880,8 +880,7 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
 
 	val = mt7530_read(priv, MT753X_MTRAP);
 
-	val |= MT7530_CHG_TRAP | MT7530_P5_MAC_SEL | MT7530_P5_DIS;
-	val &= ~MT7530_P5_RGMII_MODE & ~MT7530_P5_PHY0_SEL;
+	val &= ~MT7530_P5_PHY0_SEL & ~MT7530_P5_MAC_SEL & ~MT7530_P5_RGMII_MODE;
 
 	switch (priv->p5_mode) {
 	/* MUX_PHY_P0: P0 -> P5 -> SoC MAC */
@@ -891,15 +890,13 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
 
 	/* MUX_PHY_P4: P4 -> P5 -> SoC MAC */
 	case MUX_PHY_P4:
-		val &= ~MT7530_P5_MAC_SEL & ~MT7530_P5_DIS;
-
 		/* Setup the MAC by default for the cpu port */
 		mt7530_write(priv, MT753X_PMCR_P(5), 0x56300);
 		break;
 
 	/* GMAC5: P5 -> SoC MAC or external PHY */
 	default:
-		val &= ~MT7530_P5_DIS;
+		val |= MT7530_P5_MAC_SEL;
 		break;
 	}
 
@@ -1193,6 +1190,14 @@ mt7530_port_enable(struct dsa_switch *ds, int port,
 
 	mutex_unlock(&priv->reg_mutex);
 
+	if (priv->id != ID_MT7530 && priv->id != ID_MT7621)
+		return 0;
+
+	if (port == 5)
+		mt7530_clear(priv, MT753X_MTRAP, MT7530_P5_DIS);
+	else if (port == 6)
+		mt7530_clear(priv, MT753X_MTRAP, MT7530_P6_DIS);
+
 	return 0;
 }
 
@@ -1211,6 +1216,14 @@ mt7530_port_disable(struct dsa_switch *ds, int port)
 		   PCR_MATRIX_CLR);
 
 	mutex_unlock(&priv->reg_mutex);
+
+	if (priv->id != ID_MT7530 && priv->id != ID_MT7621)
+		return;
+
+	if (port == 5)
+		mt7530_set(priv, MT753X_MTRAP, MT7530_P5_DIS);
+	else if (port == 6)
+		mt7530_set(priv, MT753X_MTRAP, MT7530_P6_DIS);
 }
 
 static int
@@ -2401,11 +2414,11 @@ mt7530_setup(struct dsa_switch *ds)
 		mt7530_rmw(priv, MT7530_TRGMII_RD(i),
 			   RD_TAP_MASK, RD_TAP(16));
 
-	/* Enable port 6 */
-	val = mt7530_read(priv, MT753X_MTRAP);
-	val &= ~MT7530_P6_DIS & ~MT7530_PHY_INDIRECT_ACCESS;
-	val |= MT7530_CHG_TRAP;
-	mt7530_write(priv, MT753X_MTRAP, val);
+	/* Allow modifying the trap and directly access PHY registers via the
+	 * MDIO bus the switch is on.
+	 */
+	mt7530_rmw(priv, MT753X_MTRAP, MT7530_CHG_TRAP |
+		   MT7530_PHY_INDIRECT_ACCESS, MT7530_CHG_TRAP);
 
 	if ((val & MT7530_XTAL_MASK) == MT7530_XTAL_40MHZ)
 		mt7530_pll_setup(priv);
@@ -2488,8 +2501,11 @@ mt7530_setup(struct dsa_switch *ds)
 			break;
 		}
 
-		if (priv->p5_mode == MUX_PHY_P0 || priv->p5_mode == MUX_PHY_P4)
+		if (priv->p5_mode == MUX_PHY_P0 ||
+		    priv->p5_mode == MUX_PHY_P4) {
+			mt7530_clear(priv, MT753X_MTRAP, MT7530_P5_DIS);
 			mt7530_setup_port5(ds, interface);
+		}
 	}
 
 #ifdef CONFIG_GPIOLIB

-- 
2.40.1





More information about the linux-arm-kernel mailing list